Laserfiche WebLink
0 <br />Interstitial Liquid Sensor Installation Guide Installation of Float Switch <br />8. Seal wire nuts with epoxy sealant following the instructions in Figure 5. <br />I® <br />CAUTION: Epoxy sealant is irritating to eyes, respiratory system, and skin. Can cause allergic skin reaction. Contains: <br />f epoxy resin and Cycloaliphatic epoxycarboxylate. Precautions: Wear suitable protective clothing, gloves, eye, and face <br />protection. Use only in well ventilated areas. Wash thoroughly before eating, drinking, or smoking. <br />9. Push the epoxy seated bag into the junction box. Replace and tighten the junction box cover. <br />10. Tum On power to the console. <br />F •1 <br />Instructions: <br />NOTE: When temperature is below 50°F (10°C), <br />keep resin in a warm place prior to mixing (e.g., <br />in an inside pocket next to body). <br />1. Open epoxy sealant package, and remove resin <br />pak. <br />2. Holding resin pak as shown in A, bend pak along <br />long length. <br />3. As shown in B, firmly squeeze the RED SIDE of <br />the resin, forcing it through the center seal and <br />into BLACK SIDE. <br />6 <br />From probe, To console <br />sensor, or <br />transducer <br />Make sure that <br />the end of cable <br />sheathing is sub- <br />merged in sealant <br />Tie wrap <br />_ Wire nuts <br />4. Mix thoroughly to a uniform color by squeezing <br />contents back and forth 25-30 times. <br />5. Squeeze mixed, warm resin into one end of bag <br />and cutoff other end. <br />6. Slowly insert wiring connections into sealing <br />pack until they fit snugly against the opposite <br />end as shown in C. <br />7. Twist open end of bag and use tie wrap to close <br />it off and position the tie wrapped end up until <br />the resin jells. <br />probes\epxy2w.eps <br />Figure 5. Epoxy Seating Sensor Field Connections <br />