Laserfiche WebLink
UNDER DISPONSER CONTAINMENT $DC) TESTING <br />Test Method By: O Manufacturer • Industry Standard o Professional Engr o Other (see below) <br />Test Method Uses: O Pressure O vacuum • Hydrostatic o Other (see below) <br />Measuring Equipment Used: INCON TS -STS (Electronic Sump Test System) <br />Description <br />Disp # 1/2 Disp # 3/4 Disp # 5/6 <br />Disp # 7/8 <br />0:05 <br />UDC manufacturer <br />Bravo Bravo Bravo <br />Bravo <br />Initial Probe Reading <br />0.7617 <br />UDC material <br />Steel <br />FRP <br />3:53 PM <br />Final Probe Reading <br />UDC depth (inches) <br />9 <br />28 <br />Entire <br />Entire <br />Height from UDC bottom to highest <br />piping penetration <br />Bottom <br />11 <br />Was sensor removed for testing? <br />Yes <br />Height from UDC bottom to lowest <br />electrical penetration <br />Bottom <br />9 <br />Yes <br />Condition of UDC prior to testing <br />Dry <br />Dry <br />Port <br />Depth of water level from UDC bottom (in.) <br />Comments: <br />6 <br />13 <br />Wait time for water level to stabilize (hr:min) <br />0:05 <br />0:05 <br />Test start time <br />2:03 PM <br />3:38 PM <br />Initial Probe Reading <br />0.7617 <br />6.5788 <br />Test end time <br />2:18 PM <br />3:53 PM <br />Final Probe Reading <br />0.7620 <br />6.5788 <br />ion of UDC tested <br />Entire <br />Entire <br />Type of shut -down present <br />Float/Sensor <br />Float/Sensor <br />Was sensor removed for testing? <br />Yes <br />Yes <br />Was sensor properly replaced after testing? <br />Yes <br />Yes <br />Depth of water level from UDC bottom (in.) <br />Comments: <br />6 <br />13 <br />Wait time for water level to stabilize (hr:min) <br />0:05 <br />0:05 <br />Test start time <br />2:03 PM <br />3:38 PM <br />Initial Probe Reading <br />0.7617 <br />6.5788 <br />Test end time <br />2:18 PM <br />3:53 PM <br />Final Probe Reading <br />0.7620 <br />6.5788 <br />Test duration (hr:min) <br />0:15 <br />0:15 <br />Change in water level (t 0.0000 inches) <br />0.0003 <br />0.0000 <br />Pass/Fail threshold (10.0020 inches /; Hr.) <br />0.0020 <br />0.0020 <br />TEST RESULT <br />PASS <br />PASS <br />0 2011 Walton Engineering, Inc. <br />