COMPLIANCE INFO_1986-1996 - Laserfiche WebLink

Home Browse Search

27. Sensor Calibration Ste`= / (pao- 36• HYDROSTATIC PRESSURE CONTROL 31. VOLUME MEASUREMENTS (V) RECORD 10 001 GAL 34, TEMPERATURE COMPENSATION USE FACTOR lax 38. NET VOLUME CHANGING EACH READING 39. ACCUMULATED CHANGE LOG OF TEST PROCEDURES 28. DATE TIME! 12a nr 1 Record details of selling up 29. Reading and running test IUse lull No V length of tine d needed.) AT TEST LOCATION -RENNED Standpipe Levet m Inches 32. Product rn 33. Product Graduate Replaced I- i 35. 36 Change g � The+mal Higher • Sensor Lower - Reading Icl FROM FI LL PI 37. Computation {cl • tat : Expansion • Contraction - Temperature Adjustment — Volume Minus Expansion (-101 Contraction I 1 #331V1 — 0371T1 AI Low Level compul Change per Hour {NEPA cnterral Degmmng Level to of which Reading Restored ILL UPI All Before Alter Product Reading Reading Recovered I.1 PTERS, I ND SP1AC H TUBES CM SET UP EQUIPMU #1 START CIRCULATION # # FACTOR " j ) # I 4L Z # PACTOR - ) 1St MEPM READING # CPW START HIGH LEVEL TEST 42 1st HIGH ISVEL READING # 1 1, 01 It of It # 1 3 {-7 1 y HIGH LEVEL READINGS CWT. # 2 n n u 11 /1 # 2 DROP TO LOW 1= WAIT 1/2 HOW 91 91 99 91 T n u n of It # 3 102DDI It 11 1t # /1OW 01 it It 11 of # 4 fV I9 91 1/ 99 # 5 tWCA # 6 . 0 1420 �.N✓� �+'r^� t P -T Tank Test Data Chart Additional info T. Net Volume Change at Conclusion of Precision Test ...._. gph Signature of Tester: Dale 2. Statement: ❑ Tank and product handling system has been tested tight according to the Precision Test Criteria as established by regulatory agency. This is not intended to indicate permission of a leak. OR ❑ Tank and product handling systom has failed the tank lightness test according to the Precision Test Criteria as established by regulatory agency. OR n Tosl invalid dno lu unvirunntuntnl or muchanwill lnclurs hayurul cunhol of Ihu lusling uyutunrmll. It is the responsibility of the owner and/or operator of this system to immediately advise state and local authorities of any implied hazard and the possibility of any reportable pollution to the environment as a result of the indicated failure of this system. The manufacturer of this test method does not assume any responsibility or liability for any loss of product to the onvironmont. Tank Owner/Operator Delo DROP TO LOW 1= WAIT 1/2 HOW P -T Tank Test Data Chart Additional info T. Net Volume Change at Conclusion of Precision Test ...._. gph Signature of Tester: Dale 2. Statement: ❑ Tank and product handling system has been tested tight according to the Precision Test Criteria as established by regulatory agency. This is not intended to indicate permission of a leak. OR ❑ Tank and product handling systom has failed the tank lightness test according to the Precision Test Criteria as established by regulatory agency. OR n Tosl invalid dno lu unvirunntuntnl or muchanwill lnclurs hayurul cunhol of Ihu lusling uyutunrmll. It is the responsibility of the owner and/or operator of this system to immediately advise state and local authorities of any implied hazard and the possibility of any reportable pollution to the environment as a result of the indicated failure of this system. The manufacturer of this test method does not assume any responsibility or liability for any loss of product to the onvironmont. Tank Owner/Operator Delo