Laserfiche WebLink
US' SYSTEM PRINTSET INFORMATION <br />1. Four complete sets of plans (To include specification sheets and/or equipment brochures if not on file). <br />2. Plans drawn to scale in non -erasable print. <br />3. Plot plan to show location and number of tanks: <br />4. Tank cross-sectional diagram included on prints submitted. <br />5. Detail of tank, piping system, excavation and cover. <br />6. Tank(s) and piping approved by a nationally recognized independent testing organization. (Title 23, Subchapter 16, <br />Article 3, Sec. 2631 (r) & 26351 <br />7. Verification of product compatibility with the tank(s), piping, monitoring <br />—"— device(s), epoxy or silicone glues, etc. (Section 2635 (b) (2)] <br />g. Manufacturer's written installation instructions for tank(s), piping, monitoring devices, etc. (Section 2635 (b) (5)] <br />9. Tightness Test (NFPA 30) is required on both primary (10) and secondary (20) containment systems before covering. <br />(Section 2635 (b) (6) & (7)] <br />10. Double walled tanks using pressure or vacuum testing to monitor the annular space. (Section 2635 (b) (7)] <br />11. NFPA 329 "Precision Test" required upon completion of installation with tank in operating condition. Test results to <br />be submitted directly to PHS/END from the testing company or owner of facility. (Health & Safety Code, Division 20, <br />Chapter 6.7, Section 25291 (9)I <br />12. TANK COMPOSITION <br /># <br /># <br /># <br /># <br />TANK # # <br />CAPACITY Gallons 10,000 <br />10 t 000 <br />10 000 <br />10,000 <br />MANUFACTURER erxeS <br />ber- <br />COMPOSI7IONglass— <br />erxes <br />i er- <br />Xerxes <br />F'ber- <br />Xerxes <br />F ber- <br />a ELSE <br />MODEL <br />ct <br />PRODUCT aSOline) Unl <br />a Unl <br />Su Un <br />Mid- rad <br />Unl <br />ROTECTION / A <br />CORROSION PROTECTION­- <br />4/A <br />N/A <br />N/A <br />U.L. LISTED irES <br />fES <br />YES <br />YES <br />COMPATIBILITY WITH 100% <br />METHANOL ES <br />ES <br />YES <br />YES <br />13. TANK(s) TO BE INSTALLED <br />A. Steel -clad with fiberglass reinforced plastic. <br />B. Holiday test required immediately before "setting" tank(s) (35,000 - 40,000 volts). (Section 2635 (b) (4)] <br />C. Fiberglass [Sections 2635 (3) and 2631 (p)] <br />(1) Striker plate dimensions and materials. <br />(2) Striker plate under all accessible openings. <br />(3) Installation instructions require an air test and soap bubble test prior to installation. <br />_ D. Non -clad steel tank (Section 2635 (b)] <br />(1) Cathodic protection provided for entire tank, piping and components (nuts, bolts, washers, <br />etc.). <br />(2) Approved by a corrosion engineer or H.A.C.E. technician. <br />(3) eDocument stating inspection method and frequency (minimaamsemi-enmwal inspection requirement). <br />4 <br />