Laserfiche WebLink
D. Rosuhs, of Testiag/ServicARAP <br /> Software Version Installed: <br /> Complete the following checklist: <br /> U2 Yes U No* Is the audible alarm operational? <br /> El Yes L3 No* Is the visual alarm operational? <br /> U Yes L3 No* Were all sensors visually inspected, functionally tested,and confirmed operational? <br /> M Yes Q No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> LJ Yes LJ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> M N/A operational? <br /> M Yes U No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> El N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) a Sump/Trench Sensors; W Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? LKYes; U No. <br /> KI Yes L3 No* For tank systems that utilize the monitoring system as the primary tank overfill warning device_(�Leno <br /> Ll N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> FLS,e 60 1_�_tt fill point(s)and o2erating properly? If so,at what percent of tank ca acity does the alarm triaer? ,—, % <br /> U Yes* ES No Was any monitoring equipment replaced? If yes,identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> U Yes* 61 No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) U <br /> I Product; U Water. If yes,describe causes in Section E,below. <br /> Yes U No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> Yes U No* Is all monitoring equipment operational per manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 3 03/01 <br />