Laserfiche WebLink
A Results of Testin Servlean <br />Software Version Installed:y® B®a® IE GD A 4 ® 1-� <br />Camnlete the fallnwino cherklictr <br />® Yes <br />❑ No* <br />Is the audible alarm operational? - <br />U4 Yes <br />❑ No* <br />Is the visual alarm operational? <br />EJYes <br />❑ No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />M Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />❑ Yes <br />❑ No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />® N/A <br />operational? <br />M Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ® Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br />Did you confirm_positive shut -down due to leaks and sensor failure/disconnection? EQ Yes; ❑ No. <br />❑ Yes <br />❑ .No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />® N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />F1,40 <br />fill. noint(s) and operating ro erl ? If so, at what percent of tank capacity does the alarm tri er? <br />❑ Yes* <br />® No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* <br />M- No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />®- Yes <br />❑ No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />a Yes <br />❑ No* <br />Is all monitoring equipment oerational per manufacturer's specifications? <br />c�Ma� ueawaeaeeC or win oe corrected. <br />E. Comments: <br />Page 2 of 3 03/01 <br />