Laserfiche WebLink
P. Results of Testing/Servidn u <br />Software Version Installed: <br />Co fete the following checklist: <br />0 es <br />D No* <br />Is the audible alarm operational? <br />Yes <br />❑ No* <br />Is the visual alarm operational? <br />U Yes <br />No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />❑ Yes <br />o* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />❑ Yes <br />D * <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />N/A <br />operational? = <br />❑ Yes <br />❑ <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) D Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failureldisconnection? O Yes; ❑ No. <br />D Yes <br />❑ Np <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />E7"N/A <br />mechanical overfill prevention valve is instaIled), is the overfill warning alarm visible and audible at the tank <br />fillpoint(s) and opmting properly? If so, at what 2ercent of tank capacity does the alarm trigger? % <br />❑ Yes* <br />o <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. o, <br />Yes* <br />D No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />Y ' <br />D No* <br />Was monitorin system set-up reviewed to ensure proper settings? Attach set up reoons, if a2plicable <br />O"Yes <br />D No* <br />Is all monitorin equipment o ational at manufacturer's s ifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. ContinentsS -sO - '." <br />Page 2 or 3 03/01 <br />