COMPLIANCE INFO_2010-2011 - Laserfiche WebLink

Home Browse Search

mandatory immersion period and shall exhibit A5.1 SITE PREPARATION. no evidence of peeling, blistering, surface wrinkling or roughing. A5.1.1 Prior to excavation, the site shall be safeguarded from all sources of ignition for an A4.6.1.3.2 Each liquid post immersion test area of at least 25 feet in all directions. Until the sample which is adhesion tested in accordance area is vapor free, all open flame and spark with ASTM D4541-85 shall have a bond producing equipment within the area shall be strength of no less than 100 psi; and shut down. Barricades and warning signs reading Flammable - No Smoking shall be erected and posted around the vapor area. A4.6.1.3.3 Other Physical properties after the final immersion period for the above listed "Additional Liquids shall be not less than 30 A5.1.2 Fire Extinguisher. Two portable A:B:C: percent of the original physical properties type fire extinguishers each having a rating not before immersion with a stable trend indicating less than 80B:C shall be provided on the site in little or no further long-term deterioration and accordance with N.F.P.A. shall in no case be less than 50 percent of the original physical properties for any liquid to be stored in the tank. A5.1.3 Emergency Communications. A dependable method shall be available for notifying the fire department or life squad in the A4.7 HISTORICAL PERFORMANCE TEST event of an emergency. (Empirical Data) A5.1.4 Static Electricity Control. Adequate A4.7.1 For linings that have been successfully precautions shall be taken to prevent the in service for 5 years or more in underground accumulation and discharge of static electricity tanks, the manufacturer of the lining may (See NFPA 77, Recommended Practice on document to the tank owner the compatibility of Static Electricity). the lining material to the product to which the lining has been exposed. An internal inspection of the lining that has been in service for 5 years Note: Electrically isolated tanks such as tanks or more which meets the visual requirements of constructed of fiberglass, section A4.6.1.3.1, meets the adhesion test fiberglass composite, or ether requirements of section A4.6.1.3.2, passes a non-conductive material cannot holiday test as described in section A13.1.3, be relied upon as a grounding and retains a minimum of 50% of the original source. Grounding potential cured hardness of the lining material at time of should checked by a structure application shall meet the material compatibility to soil potential reading. requirements of A4.4. A5.1.5 Electrical Equipment.During site preparation,all electrical equipment used in the A5.0 GENERAL SAFETY REQUIREMENTS In