Laserfiche WebLink
This section describes the hardware, requirements, and procedures for installing the Solid -State Discriminating <br />Dispenser Pan, Discriminating Dispenser Pan, and Solid -State Dispenser Pan Sensors. <br />Installation Hardware <br />All Dispenser Pan Sensors come with the following installation hardware: <br />• One 12 -Foot Long Cable (including connector) <br />Note: If a longer cable is required, you may order a 20 -foot long cable (for either 2 -wire or 3 -wire sensors) <br />separately. For 2 -wire sensors, order Part No. 331102-001 ; for 3 -wire sensors, order Part No. 331103-00 1. <br />• 1 Wiring Kit <br />• Installation Instructions <br />• Mounting brackets are required and must be ordered separately. Use of Veeder-Root Universal Mounting Kit <br />(Part No. 330020-012) is recommended. <br />Table 1. Dispenser Pan Installation Hardware Part Numbers <br />Sensor <br />Cable Part No. <br />Wiring Kit Part No. <br />Solid -State Discriminating <br />Dispenser Pan <br />331103-002 <br />330020-011 <br />Discriminating Dispenser Pan <br />331102-002 <br />330020-011 <br />Solid -State Dispenser Pan <br />331102-002 <br />330020-011 <br />Installation Requirements <br />Before you install each Dispenser Pan Sensor, consider the following important requirements: <br />1. The sensor should rest in the cup or lowest point of the dispenser pan. <br />2. It is recommended that the sensor be mounted in a true vertical position to ensure proper operation of the <br />sensor. <br />3. Ensure that there will be enough room to pull the sensor straight out of the pan if service is required. <br />3 <br />