Laserfiche WebLink
CAUTION: Xerxes recommends that every site be thoroughly <br />evaluated for the. potertial to trap water or otherwise subject the <br />tank to a rise in the local water table. Xerxes recommends that <br />all tanks be anchored in installations in which water may enter <br />the hole. Failure to anchor may damage the tank or surrounding <br />property. <br />DEADMAN ANCHOR: <br />A deadman is a reinforced concrete beam with a total length 12 <br />inches greater than the overall length of the tank. A deadman may <br />be fabricated in multiple sections as long as the total length is not <br />decreased and each section contains at least two anchor points. <br />The width and thickness depend on the tank diameter. Refer to <br />Table 7-1 for speck dimensions. <br />TABLE 71 <br />TANK DIAMETER <br />(FT.) <br />DEADMAN DIMENSIONS <br />(W x D) (IN.) <br />SLAB WIDTH <br />(FT.) <br />4 <br />6" x 6" <br />6' <br />6 <br />12" x 12" <br />9'6" <br />8 <br />12" x 12" <br />11' <br />10 <br />18" x 12" <br />13.5' <br />12 <br />36" x 8" <br />15' <br />FIGURE 71 <br />FIGURE MA <br />-y the deadmen in the excavation parallel to the tank and outside <br />the tank "shadow" (See Figure 71 and 7-1A). In multiple tank <br />Aallations, each tank will require two deadmen. The minimum <br />spacing between tanks must be equal to twice the width of a single <br />deadman. One deadman may be used between two tanks if it is <br />doubled in width. Provide a separate anchor point for each <br />holddown strap. <br />ANCHOR SLAB: <br />An anchor slab is a reinforced concrete base. The total length of the <br />slab is 12" greater than the overall length of the tank. The minimum <br />slab thickness is 8". The width of the slab depends on the tank <br />diameter. Refer to Table 71 for specific dimensions. Refer to Table <br />7-2 and Figure 7-2 for anchor point dimensions. Provide a separate <br />anchor point for each holddown strap. When using a concrete base <br />slab, allow sufficient depth in the excavation for 12" of bedding <br />material below the tank (Figure 7-3). <br />TABLE 7-2 <br />TANK <br />ANCHORING DIMENSIONS <br />DIAMETER„A„ <br />J <br />„B„ <br />„C„ <br />1,E„ <br />I MIN. <br />MAX. <br />4' <br />24” <br />18" <br />12" <br />27" <br />30" <br />8'- 4'/4" <br />6' <br />35" <br />23" <br />13" <br />42" <br />48" <br />12'-1 " <br />8' <br />43" <br />31 " <br />15" <br />52"#75" <br />15'-1 " <br />10' <br />57" <br />45" <br />15" <br />69" <br />8' 83/<12' <br />58" <br />50" 23" <br />87" <br />2'- 63/0" <br />RS <br />MMIN <br />9MM <br />ME MM <br />® <br />®M <br />M®�BWWE�W,111B®�® <br />®® ME ME MMU®® <br />FIGURE 7-2 <br />FIGURE 7-3 <br />F] <br />P] <br />