Laserfiche WebLink
5 ® r <br /> lip <br /> 3B-Relntoread Diamond Plate <br /> with special cam lock mach's. Tubular <br /> and Grade 8 Cad Plated Bolts -O•Ring <br /> with seals. <br /> 12 Ga.Rolled <br /> Steel Frame High Density Polyethylene Nylon Collector <br /> Sump Shield#SC-3001-SS <br /> I <br /> t <br /> INSTALLATION INSTRUCTIONS <br /> To set the elevation for the fiberglass sump, the optimum over sump and spill collector bucket. It may be to your <br /> position should be 8" below finished concrete or asphalt advantage to leave offspill collector bucket "O"ring on this <br /> grade. This allows a I" overlap for steel spill collector initial installation and after concrete is poured then remove <br /> frame when itis elevated I"above finished concrete grade. lid and install "O"rings to final installation. <br /> This elevation setting also positions the light weight high Besure when lidand frame areinstalled that 36"lidis atleast <br /> density polyethylene sump shield, number SC-3601-SS to 1"above finished concrete grade andthat collector bucketis <br /> the right position for eliminating water intrusion. Cut the 2•below flange in collector. <br /> 4" SIl pipe riser to a length of 14 1/2' below 5nfshed r <br /> concrete grade. (Not the 1" elevated grade) If these instructions are followed you should have an <br /> ARer all grades are set and tanks are back filled to top of attractive and easy installation. <br /> fiberglass sump, Spill Collector can be installed. Now SUMP COVER LID REMOVAL <br /> install the light weight high-density p-ty a-sem For ease ofi emoval we have hrmishedJack screws. First, <br /> shield with the proper openings cut out. Then install the tum affhold down bolts(1/2 Hex)counter clockwise to stop. <br /> nylon spill collector bucket, hand tighten against "O"ring, Next,remove button head alien screws(Do not d/sca rd)rnsert <br /> if the Spill Collector is used on the vapor side install vapor "7"handle Jack screws in threaded hole(if T"handles are <br /> spill collector now. (Vapor spill collector is different. It is not available use 5/16"-18 bolts)and raise lid. When lid is <br /> 1"shorter on the 4"riser, be sure to check this). free from collector bucket "O"ring use "T'handle to lift lid <br /> ')w the spill collectorfid and frame can be installed. Using from sump. <br /> ..,e cam lock mechanism to fasten the lid to the Same by To replace L'd simply lower lid over spill collector buckets. <br /> turning bolts clockwise until cams inter-lock with dimples Remove-T-handles and press lid into place, tum hex bolts <br /> in frame, then tighten approximately one tum more to clockwise until pressure is felt, then in cross lid tightening = <br /> tighten down against seal. (Do this in a cross Had pattern pattern, tighten bolts to draw lid down against the seal <br /> which will apply even pressure on seal). After the lid is evenly. Please re-Install the betton headatren scrvws- <br /> properly installed on the frame. it can now be positioned <br />