Laserfiche WebLink
i <br />D. Results of Testing/Servicing <br />Software Version Installed: <br />('nm plata tha fnllnwina PhPoirliet- <br />(X)Yes <br />❑ No* <br />Is the audible alarm operational? <br />(X )Yes <br />❑ No* <br />Is the visual alarm operational? <br />( )Yes <br />❑ No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />(X)Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />( ) Yes <br />( ) No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />(X)N/A <br />operational? <br />( ) Yes <br />( ) No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />(X)N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? ❑ Yes; ❑ No. <br />( ) Yes <br />( ) No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />(X)N/A <br />mechanical�overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fill oint(s)`and operating properly? If so, at what percent of tank capacity cbes the alarm trigger? % <br />(X Yes* <br />( ) No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />(X Yes* <br />( ) No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) '�B <br />Product; O Water. If yes, describe causes in Section E, below. <br />( )Yes <br />❑ No* <br />Was monitorings stem set-up reviewed to ensure proper settings? Attach set up re orts, if applicable <br />I <br />( )Yes <br />❑ No* <br />Is all monitoring equipment oerational 2er manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: FOUND ABOUT 3 GALLONS OF WATER IN DIESEL ON OPPOSITE SIDE <br />FROM SENSOR. REMOVED WATER & LEFT ON SITE. THE SYSTEM WAS NOT IN <br />Monitoring System Certification Page 2 of 4 12/07 <br />