Laserfiche WebLink
Software Version Installed: <br />!'�.. ..H..L.. 4H.o f HL. >ino nF�nnlrlee4• <br />* In Section E below, describe how and when these deficiencies were or win De correctea. <br />E. Comments: <br />Page 2 of 3 03/01 <br />❑ No* <br />Is the audible alarm o erational? <br />Ye <br />—0 No* <br />Is the visual alarm operational? <br />UVY e <br />❑ No* <br />Were all sensors visually inspected, functionally tested, and confirme erational? <br />es <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their pLo2er operation? <br />❑ Yes <br />❑ Nol <br />-•If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />N/A <br />operational? <br />❑ Yes <br />❑ N01— <br />F6r pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? ❑ Yes; ❑ No. <br />❑ Yes <br />❑. N * <br />or tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />ill point(s)and operating ro erl ? If so, at what percent of tank capacity does the alarm trigger? % <br />❑ Yes* <br />Pia <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />d -list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* <br />o <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />No* <br />Was monitoringsystem set-upreviewed to ensure proper settings? Attach set u reports, if applicable <br />Ves <br />es <br />❑ No* <br />Is all monitorin a ui mento erational per manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or win De correctea. <br />E. Comments: <br />Page 2 of 3 03/01 <br />