Laserfiche WebLink
D. results of Testing/Servici <br />Software Version lnstalled: <br />Cow0fete the following ch <br />* In Section E below, describe how and when these deficiencies were or will be corn <br />E. Comments: 1111-o s -,H A-77-t� c w .1 <br />1-101ACA (-' r Se n f'o �- <br />Page 2 of 3 <br />03/01 <br />❑ No* <br />Is the audible alarmoperational? <br />s <br />❑ No* <br />Is the visual alarmoperational? <br />s <br />❑ No* <br />Were all sensors visually inspected, functional) tested, and confirmed operational? <br />Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />not interfere with their operation? <br />❑ Yes <br />❑ * <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />-N/A <br />operational? - <br />Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to ope�ra�te' or is electrically disconnected? If yes: which sensors initiate <br />" <br />positive shut -down? (Check all that apply) H Sump/Trench Sensors; l Dispenser Co nment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? O"Yes; ❑ No. <br />Yes <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />❑ N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fill int(s) and o ro erl ? If so, at what percent of tank capacity does the alarm trigger? <br />❑ Yes* <br />Ef No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced 1 <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* <br />No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all rha, apply) ❑ <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />es <br />❑ No* <br />Was toring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />ET Yes <br />❑ No* <br />Is all monitoring i ment opgational pff manufacturer's iftcations? <br />* In Section E below, describe how and when these deficiencies were or will be corn <br />E. Comments: 1111-o s -,H A-77-t� c w .1 <br />1-101ACA (-' r Se n f'o �- <br />Page 2 of 3 <br />03/01 <br />