COMPLIANCE INFO_2016-2017 - Laserfiche WebLink

Home Browse Search

installationSummary of Installation These steps are not a substitute for the detailed '•s contained following •a • • • ' ' • A, 1 ' • 0 : 1 1 • • A Z I 1 • 1) Read the entire manual front to back, read carefully. Do not just view images. 2) Evaluate the sump, ensure sump material is FRP, and the piping is FRP or conduit. 3) Remove any necessary components that will obstruct your access to the sump wall. Excavate adequate area on outside of all fittings you will install. 4) Clean each sump. Remove all contaminants, water and debris. Ensure each sump will be completely dry during all installation steps. 5) Secure conduit endpoints so they do not move or act as a lever. 6) Remove the interior boot and all of it's components or sealants from the wall and pipe. 7) Push existing bolts back into the backfill. Do not damage the sump wall doing this. 8) Properly protect the pipe or conduit against damage. 9) Abrade the interior of sump wall around hole until bare fiberglass is showrr 10) Clean, dry and rough up pipe or conduit surface in preparation for bonding. DE -C 0 7 2016 11) Dust off all abraded surfaces with compressed air. ENYJ4 �. EF r12 Dry -fit our fittings for clean ft against the wall and piping. Mark alignment strip across the fitting halves and the sump wall with a permanent marker. 13) Bond split fitting to the interior of sump by manually pressing fitting halves firmly against the sump wall using hand strength. 14) Bead excess adhesive around primary seam at the wall and at the pipe. 15) Use acetone to clean the face of each fitting to look like a new install. Clamp halves together tight and re -clean any adhesive that oozes. 16) Allow adhesive to fully cure before testing fitting installation. Do not disturb while curing! 17) Mandatory Pressure/soap test to verify the fitting installation is good. 6 ii -F -Series -Retrofit -S -13B