COMPLIANCE INFO_2012-2018 - Laserfiche WebLink

Home Browse Search

-)ECEIVED D. Results of Testing/Servicing FEB 2 12017 Software Version Installed: 120.00 if ttL Complete the following checklist: „. �_s n:P&P IF T 0 Yes ❑ No* Is the audible alarm operational? ❑x Yes ❑ No* Is the visual alarm operational? ON Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? QYes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their ro r• o ration? ❑X Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) ❑ N/A operational? ❑ Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary ❑x N/A containment monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor failure/disconnection? ❑ Yes; El No. ® Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the does tank fill point(s) and operating properly? If so, at what percent of tank capacity the alarm trigger? ®Yes* ® No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. ❑Yes* MNo Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; ❑ Water. If yes, describe causes in Section E, below. 0 Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? *In Section E below, describe how and when these deficiencies were or will be corrected. E. Comments: Other sensors from page 1: L3: Vent sump sensor -794380-208/ 515989 -Certified. L4: Transition sump sensor -794380-208/ 1076768 -Certified. L5: Inside piping pan sensor -794390-420/ 793173 -Certified. An overfill prevention valve is located in the drop tube.