COMPLIANCE INFO_2002-2006 - Laserfiche WebLink

Home Browse Search

FASTENERS-> ENTRY BOOT TEMPLATE-� STEP 1 STEP 2 STEP 3 STEP 4 Locate the center entry point in the flat After the bolt hole circle has been Install the rubber boot from outside the Using a 7/16"nut driver,tighten all of the wall section of the sump base and drill drilled,drill out the entry!tet opening sump by inserting the studs through the nuts evenly and firmly. To prevent a 5/16" hole. Install the Entry Boot by using the appropriate size hole saw. bolt holes.From the inside of the sump, deforming boots do not over tighten Template to the sump base wall using After drilling out opening, clean any install the compression ring over the nuts. If a torque wrench is used, the a 1/4" bolt and nut. Drill out the rough edges with a razor knife.Refer to studs and install nuts by hand. setting should be 60 in.lbs. appropriate bolt hole circle for the size chart for hole saw sizes. boot to be installed using the same 5/16"drill bit After drilling remove the template from the sump base wall. STEP 5 ANGLED ENTRIES ROUND SURFACE INSTALLATIONS Insert the appropriate sized pipe or The Flexible Entry Boot is flexible Flexible Entry Boots may be installed on round surfaces which have a diameter conduit into the flexible boot from enough to permit angled pipe or conduit greater than 3d'.The installation procedures are the same as described above outside of the sump. After the pipe or entries up to 15° in each direction. except the 5/16"bolt holes should be made slightly larger after initial drilling.This can conduit has been positioned,install the Angles greater than 15'could prevent be accomplished by moving the 5/16"bit from side to side in each bolt hole after the band clamp around the boot and the boot from sealing around the pipe Entry Boot Template has been removed.This will enable the entry boot studs to tighten to 30 in.lbs. or conduit move slightly inward when tightening down the nut fasteners.Tighten down each nut in stages so the toot flange and compression ring can evenly conform to the rounded surface. CONEBOOT REPAIR KR BOOT REPAIR KIT ® 0 In the event that a flexible entry boot becomes damaged after installation it a� 0 ® may be repaired by using the"Boot Repair Kit".The repair requires the partial removal of the flexible entry boot cone and replacement of a flanged cone W�D 0 0 which is bolted into place. 0 ® 0 GUIDE SPECIFICATIONS Pipe&Conduit Entries:All containment chambers shall be fitted with pipe and conduit entry seals which are semi-absorbent to ground movement and sufficiently flexible enough to permit angled entries up to 15°off the center line without leaking under liquid head pressures of up to six feet(1.8m)No metallic components shall be exposed to the ground.All pipe and conduit entries shall be listed with Underwriters Laboratories,Inc Product Compatibility: All components of the secondarily contained underground liquid distribution system shall be chemically compatible with the products to be distributed and with chemicals found naturally in the ground environment Corrosion Resistance:All components of secondarily contained underground liquid distribution system which come in contact with the ground environment shall be made of non-metallic material or protected by materials which prevent corrosion. Environ Products Inc • 252 Welsh Pool Road • Lionville,PA 19341 •Telephone: (610)594-0297• Customer Service: (800)833-1883 • Fax: (610)594-9042