COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

5.2.1 . A (Y) Screen Filter (supplied with the system) shall be 7 . MAINTENANCE attached in line, before the hose. 7. 1 . Aboveground UL 142 tanks require basic maintenance during 5.2.2. Mount the hose hanging bracket (provided) on the system's the service life. The tank vessel is subject to accidental damage, cabinet, at 18" from the top of the primary tank. Do not vandalism, and atmospheric degradation of the coating. penetrate the system's cabinet anywhere below the level of the primary tank. 7.2. Failure to adhere to and provide proof of proper maintenance may void your warranty. 5 .3. Remote Caddie Discharge: A 3/4" galvanized pipe for suction line may be installed parallel with the air line, if a remote caddie 7.3. For procedures on how to check for the presence of water and discharge location is desired. A maximum 40 feet of horizontal removal of water, refer to API Recommended Practice 1621 and pipe is recommended to provide optimum pumping rate. Actual API Standard 2610* pumping rate may vary due to distance and size of piping. 7.4. The tank operator should perform weekly visual inspections to 5.3. 1 . The 8' suction hose must be installed at the end of the identify areas of damage to the vessel or the coating itself. Such piping, and within 3' of the air line on/off valve location. The damage should be repaired, line must be anchored securely in accordance with local plumbing codes. 89 ADDITIONAL REQUIREMENTS : 5.3.2. A (Y) Screen Filter (supplied with the system) shall be 8. 1 . This tank must be installed in accordance with NFPA 30, NFPA attached in line, before the hose. 30A, Uniform Fire Code or International Fire Code. 5.3.3. The suction hose hanging bracket (provided) is permanently 8.2 . The product stored within the tank is compatible with steel and mounted at a workable point near the site where the meets ASTM standards. Any fluid which does not meet ASTM hardwall suction hose connects to the galvanized suction standards must be compatible with steel and approved for line. storage in writing by CSI . Storing any fluid in the tank which is either not compatible with steel or not approved for storage by 5.3.4. All wall penetrations must be sealed according to building CSI will void the tank warranty, standards and/or local codes. 5.3.5. Coat all iron pipe fittings and joints with a rust resistive primer. WORKING6. 6.1 . A 2" galvanized steel pipe shall be extended from the primary tank through the back side of the secondary containment cabinet enclosure. It should extend vertically to a point 18" above the roof line, or per local code. 6. 1 . 1 . Install the working vent mushroom cap (provided) at the top of the vent riser pipe. 6.1 .2. All wall and roof penetrations must be sealed according to building standards and or local codes. 1 P i CONTAINMENT S O L U T I O N S® Copyright © Containment Solutions, Inc. • All Rights Reserved • Month Year • Pub. No, SW 55076 2 i I i'