ARCHIVED REPORTS_2008_27 - Laserfiche WebLink

Home Browse Search

WMU FU-08 October 2008 Forward Landfill Project No. 021605.08 Non-Destructive Seam Continuity Testing: After seaming of the panels was completed, the Contractor's QC technician and Vector's CQA Monitor inspected the seams and panels for defects. The QC technician marked defective seams or tears, holes, non-dispersed resin beads or other defects for repair. The air pressure test method was used for double wedge-welded seams and the vacuum box for extruded seams for seam continuity testing. Vector's CQA Monitor observed the non- destructive seam continuity testing and repairs performed by Comanco to ensure that the seams were satisfactory. The air pressure test logs for the wedge-welded seams are presented in the seaming log in Appendix I. Destructive Seam Testing: General - In addition to non-destructive testing, destructive samples were obtained at random locations to evaluate seam strength and integrity. The samples were tested for shear strength and peel strength (ASTM D6392). Location and Frequency — Vector's CQA Monitor selected the locations of q 3' approximately one sample per 500 linear feet of seam. Within the Central Portion of WMU FU-08, a total of 51 destructive samples were collected and tested from approximately 24,439 linear feet of seam, resulting in a frequency of 1 test per 479 linear feet. Additional destructive samples were obtained if there were failures or if there was an indication of overheating, contamination, or other adverse conditions. Sampling Procedure - Comanco cut the samples as directed by Vector's CQA Monitor. Vector's CQA Monitor observed the cutting and assigned sample numbers, and reviewed sample information (sample number, seam number, seaming apparatus, operator identification, location, date, and time welded). Vector's CQA Monitor recorded the samples collected and sample location on the panel layout drawing. Vector Engineering, Inc. • 143E Spring Hill Drive•Grass Valley,CA 95945•(530)272-2448 -28-