Laserfiche WebLink
E <br />E <br />E <br />4. Geocomposite panels shall be of sufficient continuous length to cover the <br />entire slope, including anchor trenches and runouts, without horizontal <br />seaming. <br />C. Geotextile shall be thermally bonded to geonet components of Geocomposite <br />material rather than chemically bonded. <br />2.3 MANUFACTURING QUALITY CONTROL <br />A. The Geocomposite shall be manufactured with quality control procedures sufficient <br />for certification requirements of this section and that meet generally accepted <br />industry standards. <br />B. The Geocomposite Manufacturer shall sample and test the Geocomposite to <br />demonstrate that the material conforms to all requirements of this section. <br />C. Any Geocomposite sample that does not comply with this section will result in <br />rejection of the roll from which the sample was obtained. The GEOSYNTHETICS <br />CONTRACTOR shall replace any rejected rolls at no additional cost to the OWNER. <br />D. If a Geocomposite sample fails to meet the quality control requirements of this <br />section, the OWNER will require that the GEOSYNTHETICS CONTRACTOR <br />sample and test each roll manufactured in the same lot, or at the same time, as the <br />failingroll. Sampling and testing of rolls shall continue until a pattern of acceptable <br />test results is established. <br />E. Additional sample testing may be performed, at the GEOSYNTHETIC <br />CONTRACTOWs discretion and expense, to more closely identify any non- <br />complying rolls and/or to qualify individual rolls. Sampling shall, in general, be <br />performed on sacrificial portions of the Geocomposite material such that repair is not <br />required. <br />11 <br />r.111TI Ivi <br />010i"Int'ri ji <br />FL4 -6xe, <br />C&A'Vk�osje_ <br />P"a-di JL- �)-_Q -&e" <br />Ala <br />MEMIKS2 TEST <br />ER_OCEDURE <br />Cs net Component Specific gravity <br />ASTM D 7928 <br />Thickness <br />ASTM D 5199 <br />Carbon black <br />AS DAZJS <br />Mass per unit area ASTM, D 5261 <br />Apparent opening size ASTM D 4751 <br />Permittivity ASTM D 4491 <br />