Laserfiche WebLink
the model tests appear to confirm one another. <br /> Drumm, E. C., et. Al. also used finite element analysis to evaluate the deformation of <br /> highly plastic soils in contact with cavitose bedrock. The calculated settlements were presented <br /> as a function of cavity size in a paper titled "Analysis of Plastic Soil in Contact with Cavitose <br /> Bedrock" (5). <br /> placement Method. "Closed-form" solutions for the strain field in an initially isotropic and <br /> homogeneous incompressible soil due to near-surface ground loss were presented by Sagaseta, <br /> C. (11). The differential gettlement of a point.on a plane is calculated in this method, as x <br /> function of the-displacement of-other points. The applications of the closed form solutions to <br /> some typical problems indicate that the calculated movements agree gttite well with experimental <br /> observations and compare €avorably with other commonly used numerical methods. <br /> Elastic Solution. In the Conference of Engineering Geology of Underground Movements, in <br /> September 1987, an analytical elastic method to evaluate settlements caused by voids at depth <br /> was presented by Y. Tsur.LUvie, et. al. The method can be used to calculate the surface <br /> settlement as a function of the dimension of the void., thickness of medium (soil/ruck) over the <br /> void, and Poisson's ratios. !The method presented is based on a solution developed by Goleeki <br /> (7,8) for stresses and displacements in an infinite homogeneous elastic half space, with <br /> Alk -discontinuous step-like uniform boundarydisplacement,representing the collapsing of a void. <br /> Ile displacement in the surrounding medium and the resulting differential settlement at t' <br /> medium surface is then calculated by the elastic method. <br /> The resu-its obtained::' from the analytical elastic method were compared with British <br /> National Coal Board (NCB) mining subsidence field measurement data by Tsur-l-avie, et. al., <br /> and are in close agreement with one another. <br /> SmmaQY. Several analytical and numerical methods are presented in the previous sections. All <br /> the methods discussed are capable of calculating differential settlements resulting from the <br /> existence of a void at depth'. <br /> The numerical methods discussed, i.e., the finite element and the finite difference <br /> methods, are suitable for `the analysis of problems with nonhomogeneous, anisotropical <br /> materials. However, the displacement method and the elastic solution method discussed above, <br /> require little or no material properties for the analysis, and therefore can be readily applied to. <br /> a vertical expansion design.; Of these two methods, the elastic solution has the advantage that <br /> it has been calibrated by field measurements and it allows the performance of sensitivity analysts <br /> based on different soil or waste characteristics. The elastic solution method is easier to apply <br /> than the finite element analysis, and since it neglects arching in the waste, it also provides <br /> conservative results. <br /> The following section discusses how Tsur-Lavie, et. al's Elastic Solution Method w-. <br /> 1500- Vancouver,Canada -Geosynthetics'93 <br />