Laserfiche WebLink
SECTION 02778 <br /> HIGH DENSITY POLYETHYLENE(HDPE)GEOMEMBRANE <br /> PARTl GENERAL <br /> 1.1 WORK INCLUDED <br /> A. This section covers the Work necessary to furnish and install 60-mil double-sided <br /> textured high density polyethylene (HDPE) geomembrane liner in WMU FU-14, <br /> complete. <br /> B. The GEOSYNTHETICS CONTRACTOR shall furnish all labor,supervision,tools, <br /> equipment,and materials necessary to complete the HDPE geomembrane installation <br /> including,but not limited to,submittals,panel layout,seaming,patching,temporary <br /> anchorage,temporary slip sheeting,and all necessary and incidental items required to <br /> complete the Work in accordance with these Specifications and the Construction <br /> Drawings. The EARTHWORK CONTRACTOR will perform excavation and <br /> backfilling of anchor trenches and will unload the HDPE geomembrane if the <br /> GEOSYNTHETICS CONTRACTOR is not onsite. <br /> C. A leak location test will be performed on the geomembrane before and after <br /> placement of the granular drainage material and protective operations layer. The <br /> GEOSYNTHETICS CONTRACTOR shall be responsible for repairing all identified <br /> leaks in the geomembrane prior to placement of the overlying earthwork and <br /> geosynthetic materials at his sole expense. The EARTHWORK CONTRACTOR <br /> shall be responsible for repairing all identified leaks in the geomembrane following <br /> placement of the overlying earthwork and geosynthetic materials. The • <br /> EARTHWORK CONTRACTOR shall remove all earthwork and geosynthetic <br /> materials overlying the geomembrane to the extent required to repair the leak and <br /> shall repair all identified leaks in the geomembrane at his sole expense. Following <br /> the repair of the leak in the geomembrane,the EARTHWORK CONTRACTOR shall <br /> replace all earthwork and geosynthetic materials at his sole expense. All Work <br /> performed to repair and replace materials shall be performed in accordance with the <br /> applicable Specifications sections. <br /> 1.2 REFERENCES <br /> A. American Society for Testing and Materials(ASTM): <br /> 1. D638, Standard Test Method for Tensile Properties of Plastics. <br /> 2. D746, Standard Test Method for Brittleness Temperature of Plastics and <br /> Elastomers by Impact. <br /> 3. D792,Standard Test Methods for Specific Gravity and Density of Plastics by <br /> Displacement. <br /> 4. D1004,Standard Test Method for Initial Tear Resistance of Plastic Film and <br /> Sheeting. <br /> 5. D1204,Standard Test Method for Linear Dimensional Changes of Nonrigid <br /> Thermoplastic Sheeting or Film at Elevated Temperature. <br /> 6. D 1238,Standard Test Method for Flow Rates of Thermoplastics by Extrusion <br /> Plastometer. <br /> Forward Landfill WMU FU-14 HIGH DENSITY POLYETHYLENE <br /> 02778 1 (HDPE)GEOMEMBRANE <br />