Laserfiche WebLink
3.7. Manufacturing Quality Control -The GCL shall be tested for compliance with this <br /> specification by the test methods and frequencies indicated on the material <br /> specification in Appendix A or B as appropriate. GCL materials may be tested pre- <br /> approved at the manufacturing location. <br /> 3.7.1. Manufacturer Quality Control Certification- Quality Control certificates shall <br /> be issued by the GCL manufacturer to the project engineer, CQA inspector or <br /> other designated party for each delivery of material. The certifications shall be <br /> signed by the quality control manager of the GCL manufacturer or other <br /> responsible party and shall include the following information: <br /> - Shipment Packing List- A list indicating the rolls shipped on a particular <br /> truckload. <br /> - Bill of Lading - The shipping documents for the truck used for the shipment. <br /> - Letter of Certification-The letter indicating the material is in conformance <br /> with the physical properties specified. <br /> - Physical Properties Sheet- The material specification for the GCL supplied <br /> in accordance with this specification. <br /> 3.7.2. Manufacturer Quality Control Submittal - Quality Control submittals shall be <br /> issued by the GCL manufacturer to the project engineer, CQA inspector or <br /> other designated party for each lot of material if necessary. The submittals <br /> shall include the following information: <br /> 3.7.2.1. Bentonite Manufacturer Certification- Bentonite manufacturer quality <br /> documentation for the particular lot of clay used in the production of <br /> the rolls delivered. <br /> 3.7.2.2. Geotextile Manufacturer Certification- Geotextile manufacturer <br /> quality control documentation for the particular lots of geotextiles used <br /> in the production of the rolls delivered. <br /> 3.7.2.3. GCL Manufacturer Tracking List- Cross referencing list delineating <br /> the corresponding geotextile and bentonite lots for the materials used <br /> in the production of the rolls delivered. <br /> 3.7.2.4. Manufacturing Quality Control Data - The manufacturing quality <br /> control test data indicating the actual test values obtained when tested <br /> at the appropriate frequencies for the properties specified in Appendix <br /> A or B. <br /> 3.8. . Packaging-All GCL rolls shall be packaged in moisture resistant plastic sleeves. The <br /> cardboard cores shall be sufficiently strong to resist collapse during transit and <br /> handling. <br /> 3.9. Roll Identification and Labeling -Prior to shipment, the manufacturer shall label each <br /> roll, both on the GCL roll and on the surface of the plastic protective sleeve. Labels <br /> shall be resistant to fading and moisture degradation to ensure legibility at the time of <br /> the installation. At a minimum the roll labels shall identify the following: <br /> - Length and width of roll <br /> - Total weight of roll <br /> - Type of GCL material <br /> Bentofix Drop-In Specification Bentofix is a registered trademark ofNAUE GmbH&Co.KG <br /> 6 RI/13/06 <br />