COMPLIANCE INFO_2016-2017 - Laserfiche WebLink

Home Browse Search

Si 4 Site Plan The site plan depicts two (2) proposed loading zones and one (1) proposed "bunker" area. Pursuant to Development Title Section 9-1015.3(a), for parking and loading of commercial trucks, one (1) space is required for every use with 3,000 square feet of gross floor area or more. Spaces are to be a minimum of twenty-four feet (24') in length and fifteen feet (15') in width, with a minimum height clearance of fourteen feet (14'). If a full application is submitted, the size of the loading and bunker areas should be shown on the revised plan. The site plan also depicts one (1) proposed access gate. Pursuant to Development Title Section 9-1022.2(0, gates are required to be set back or recessed a minimum of ten feet (10')from the property line unless there are at least sixteen feet (16') between the property line and the edge of the travelled roadway in which case the set back requirement is waived. If a full application is submitted, ffie gate set back should be shown on the revised plan. A proposed portable wood chipper-7is--also depicted on the site plan. If a full application is submitted, additional information on the proposed site and operation of the portable wood chipper should be included. Parking Spaces The application depicts four(4) parking spaces and0 n (1) accessible space but doesn't depict the dimensions or surface material of the spaces. Pursuant to Development Title Table 9- 1015.3(b), 2.5 parking spaces are required for each 1,000 square feet of building area for the Agricultural Waste use type. Also pursuant to Development Title 9.1015.5(b)(1), each parking space shall be an unobstructed rectangle, minimum nine (9)feet wide and twenty (20)feet long. The applicant is proposing to construct a 160 square foot building.As a result, one parking space is required for the proposed use. If a full application is submitted,the site plan should include the dimensions of the spaces. Surfacing ---IQ The site plan depicts gravel roads and driveways throughout the project area. Pursuant to Development Title Section 9-1015.5(e), all permanent parking lots (which includes parking spaces, driveways, and man ), in all zoning districts shall be surfaced and as " z permanently maintained wit asphalt or Portland cement concrete to provide a durable dust free surface. Ingress an s Ireas th t connect to a paved road or highway shall also be VVM s surfaced and permanently maintained with as alt concrete or Portland cement concrete. Pursuant to Development Title Section 9-1015.9, requirements of the chapter may be modified by the Director in cases in which, due to the unusual nature of the establishment proposed or the development proposal submitted for it,the requirements set forth in the Development Title may be considered insufficient or excessive. If a full application is submitted, the site plan should depict the required surfacing material or a letter requesting a surfacing modificatihould be submitted for review. Access 72,5 The proposed site plan depicts access driveways with a width of twenty(20)feet for two-way traffic. Pursuant to Development Title Section 9-1015.5(h)(1), access driveways shall have a width of no less than twenty-five(25)feet for two-way aisles and sixteen (16)feet for one-way aisles except that in no case shall driveways designated as fire department access be less than twenty(20)feet wide. If a full application is submitted,the site plan should show that all driveways meet the minimum standard.