COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM(Page 4 of s) VIII. MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational? ❑X ❑ Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, functionally tested,and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? Was monitoring system set-up reviewed to ensure proper settings? Q Was the monitoring panel's backup battery visually inspected,functionally tested,and confirmed operational? Q Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? ❑X ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically disconnected? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? Which sensors initiate positive shut down? (Check all that apply.) ❑X Sump ❑X Under-Dispenser Containment ❑X ❑ ❑ If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? E] ❑ ❑X For any answer of"M'above,describe in Section/X how and when these deficiencies were or will be corrected. IX. COMMENTS X. IN-TANK GAUGING TESTING FX]Check this box if tank gauging is used only for inventory control.(Do not complete this section.) ❑Check this box if NO tank gauging equipment is installed.(Do not complete this section.) Y N NA This section must be completed if in-tank gauging is used to perform leak detection monitoring, Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination, including testing for round faults? El El El Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely,functionally tested,and confirmed operational? Was accuracy of system's product level readings tested? ❑ Was accuracy of system's water level readings tested? 1:1 0 ❑ Were all probes reinstalled properly? ❑ El ❑ Were all items on the equipment manufacturer's maintenance checklist completed? 1:1 El 0 For any answer of"M'above, describe in Section XI how and when these deficiencies were or will be corrected. XI. COMMENTS Y=Yes,N=No,NA=Not Applicable