COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM ( Page 4 of e VIII . MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitorintY. YN NA Are the visual and audible alarms operational? Q r., Q Were all sensors visuals Inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely Q ❑ ❑ functionally tested and confirmed operational? Were all sensors Installed at lowest point of secondary containment and positioned so that other equipment will not Interfere with that Q ❑ a proper operation? Was monitoring system set-up reviewed to ensure proper settings? QPEI ❑ Was the monitoring panel's backup battery visually inspected functionally tested and confirmed operational? Q ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment?Does the turbine automatically shut down If the piping secondary containment monitoring system fails to operate or is electricall ❑ a disconnected? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? ❑ ❑ Q Which sensors initiate positive shutdown? (Check all that apply. ) Sum ❑ UnderAlspenser containment If alarms are relayed to a remote monitoring station is all communications equipment feu modem ) operational? ❑ ❑ Q For any answer of "N" above describe In section IX how and when these deficiencies were or will be corrected. IX. COMMENTS X. INJANK GAUGING TESTING IS/I Check this box if tank nauqlnq Is used only for Inventory control. Do not complete this section. ri Check this box if NO tank gauging egulpment Is installed (Do not complete this section ) Y N NA This section must be completed If in-tank juaugin Is used to perform leak detection monitoring, Has all input Wrinq been inspected for kinks and breaks in the cables and for proper entry and termination including testing for ground ❑ ❑ ❑ faults? Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely functionally tested ❑ ❑ ❑ and confirmed operational? Was accuracy of system's product level readings tested? ❑ ❑ ❑ Was accuracy of system's water level readings tested? ❑ ❑ ❑ Were all probes reinstalled properly? ❑ ❑ ❑ Were all Items on the equipment manufacturer's maintenance checklist completed? ❑ ❑ ❑ For any answer of "N" above describe in section X1 how and when these deficiencies were or will be corrected. XI . COMMENTS I E d tEt