COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

ffffl'C ® TS- STS SumpSystemTest Pg , Franklin Fueling Systems Quick eGuide TS-STS Overview 1 TS-STS Installation The TS-STS system includes a TS-STS console within a convenient I portable case, leak testing probes with 50 feet of cable, and probe 1.) Required Materials: hanging hardware (slip rings and chain). a.) Tape to secure the probe cable b.) Safety cones & signs After all fittings within the sump are sealed, the sump is filled with a c.) Grounded, 3-pronged extension cord water-based test solution that covers all sump penetration holes. The probe is installed so the float is floating on the surface of the test solution. d.) Flat pieces of metal to suspend leak testing probe over sumps The TS-STS console is quickly programmed with the site name and 2 ) Work safely— install Safety Cones and Signs at the site address, number of sumps, the 7-digit code-names for each sump, and the correct Time/Day/Date before leak testing. 3.) The probes are precision instruments— handle with care! Pressing the Test key at the console keypad starts sump leak tests for 4.) The STS probes are shipped with cables attached, do not remove all sumps. The test time is 15 minutes and tests for a level change the cable from the probe end... remove at the console case only. greater than 0.002 inches. If the level of a sump drops more than the 5.) Inspect probes for proper float movement before use, then install leak limit during the test, the Sump Leak Test Report will show a fail probes as shown in Section 1 result when the test is finished. Leak tests can also be programmed (scheduled) to start at desired times. 6.) Connect the yellow probe cables to the receptacles at the TS-STS When finished, leak test reports will automatically print out at the console case. Make sure to line up keyways before inserting cable and tightening the screw-on connector. printer. Extra copies of this report can be printed using the report key. A newly completed Sump Leak Test will overwrite the previous results 7.) Locate the TS-STS case outside of the Hazardous Area and tape stored in memory. Save sump leak test reports and provide copies as the cable down to prevent probe movement during the test and to evidence of compliance with regulations. reduce tripping hazards Recommendation: Use a computer and the Tech version of 8.) Setup/ Program the TS-STS console per Section 2 System Sentinel Tm to record site data,sump code-names, and test results. Test results can also be extracted from Comm Port 1 at 9•) Start sump leak test(s) on sumps that are ready N0the bottom of the TS-STS console (also see Section 4). 10.) Always clean, dry, and store probes in the probe carrying case after Reference Federal and State regulations for leak limit and test each use time requirements. Recommendations for locating the TS-STS console outside of the(Class 1,Division 1, Group D)Hazardous Areas 11.) Test each of the probes on a monthly basis to ensure its ability to during testing,are based on NFPA 30,NFPA 30A and NFPA 70(NEC). detect leaks. Install the probe in a test container and initiate a test. After 5 minutes, remove about 0.12 inches of water.When the test INCON P/N 000-3004 Rev.D Feb.2009 © www.fraklinfuelino.com completes, the test report should show a Failed result if the probe This document may change without prior notice. INCON® is a Registered Trademark of Franklin Fueling Systems is working properly.