ARCHIVED REPORTS_XR0011973 - Laserfiche WebLink

Home Browse Search

TABLE 1 GROUNDWATER ELEVATION AND ANALYTICAL SUMMARY ARCO Service Station No 5469 130 South Wilson Way,Stockton,California Elevation Top of Well Static Water Groundwater Groundwater Ethyl- Total Well Top of Casing Screen Level Elevation Flow GRO+ Benzene Toluene benzene Xylenes MTBE[1] Number Date (feet msl) (feet b s) (feet b s) (feet msl) Direction µ L µg/[,____ µ L µ L µ L µ L NOTES f=Results through the first quarter 2004 include purgeable hydrocarbons in the range of C6-C 10 GRO-Gasoline Range Organics QA/QC Review GRO analyzed using EPA Method 8015B All other analytes analyzed ustng EPA Method 8260B MTBE=Methyl tert butyl ether A—Data accepted without qualificanon [l]MTBE was analyzed using IISEPA Method 8020 NA=Not analyzed J=Data accepted with quahficamn [2]MTBE was analyzed using USEPA Method 8260 NC=Not calculated R=Data rejected [31 The value reported exceeds the calibration curve,but not the linear range NS=Not sampled [4]Chromatogram Pattem Weathered Gasolsne C6-C 12 ms]=mean sea level [5]The reporting limits for this sample have been raised due to the high level of a target compound bgs=below ground surface [6)The reporting Itmrt(s)for this sample have been raised due to high levels of non target mteferents [iglL=micrograms per liter [7]Sample was diluted due to high levels of Benzene <=Below detection limit for the analytical methods used [8]Hydrocarbon pat#ern is present in the requested fuel quantitation range but does not resemble the pattern of the requested fuel [9]Sample was reanalyzed past EPA recommended holding time [10]The sample was diluted due to the presence of high levels of target analytes resulting in elevated reporting limits [11]Laboratoryreportindicates discrete peak at MTBE and Benzene [12]Laboratory report indicates discrete peak at MTBE [13]The concentration indicated for this analyte is an estimated value above the calibration range of the instrument [14]This sample was analyzed beyond the EPA recommended holding time [15J Based on notes in laboratory report and conversation with laboratory(11/19102),this TPHG result is due entirely to presence of MTBE No other compounds eluted in the TPHG range (Refer to Stratus' Quarterly Groundwater Monitoring Report Third Quarter 2002 dated November 20,2002) [161 The continuing calibration standard was outside of the acceptance criteria [171 The sample was diluted due to the presence of high levels of non-target analytes resulting in elevated reporting limits [18]Discrete peak @ C6-C7 [19]Reported result is due to a discrete peak at C5 and has been rejected [20]Analyte was also reported in the associated laboratory blank as well as in the sample Result should be considered not detected [21]Initial results maybe biased high as shown by surrogate recoveries above method acceptance limits(due to matrix interference) Sample re-analyzed outside of EPA recommended hold time Initial result reported in the table,and should be considered an estimate [221 Initial result was an estimate,beyond the calibration range of the instrument Sample re analyzed beyond the EPA recommended hold time Initial result reported in the table [23]The reported results may be biased low since the analyses for these analytes were performed beyond the EPA recommended holding time of 14 days [24]The reported results may be biased low as demonstrated by a low surrogate recovery due to matrix interference [25]Initial result not confirmed by reanalysis Reanalysis performed beyond hold time Initial result reported in the table,should be considered an estimate [26]The reported result may be biased low as demonstrated by a low surrogate recovery [27]Discrete peak @ C5 [28]Analyzed EPA Method 8260B [29]The reported result may be biased low due to a low average percent recovery reported in the associated MS/MSD analysis [30]The reported result is partly due to a discrete peak in the quantitation range(probably MTBE) 5r�aru� Arco_5469_Quarterly Data 11 of 11