ARCHIVED REPORTS_XR0012003 (2) - Laserfiche WebLink

Home Browse Search

GROUNDWATER ETABLE 1 LEVATION AND ANALYTICAL SUMMARY i ARCO Service Station No 5469 130 South Wilson Way,Stockton,California Elevation Top of Well Static Water Groundwater Groundwater Ethyl- Total Well Top of Casing Screen Level Elevation Flow GRO+ Benzene Toluene benzene Xylenes MTBE[l] Number Date feet msl feet b feet h feet msl Direction µ µ ROL R OWL NOTES +=Results through the first quarter 2004 include purgeable hydrocarbons in the range of C6-C10 GRO-Gasoline Range Organics QAIQC Review GRO analyzed using EPA Method 8015B All other analytes analyzed using EPA Method 8260E MTBE=Methyl tert-butyl ether A=Data accepted without qualification [I]MTBE was analyzed using USEPA Method 8020 NA=Not analyzed 2 Y 7 Data accepted with qualification [ ]MTBE was analyzed using USEPA Method 8260 NC=Not calculated R=Data refected [3]The value reported exceeds the calibration curve but not the Imear range NS=Not sampled [4]Chromatogram Pattem Weathered Gasoline C6-C12 msl=mean sea level [5]The reporting limits for this sample have been raised due to the high level of a target compound bgs=below ground surface [6]The reporting limit(s)for this sample have been raised due to high levels of non-target mteferents µg1L=micrograms per]iter [7]Sample was diluted due to high levels of Benzene <=Below detection limit for the analytical methods used [8]Hydrocarbon patten is present in the requested fuel quantitation range but does not resemble the pattern of the requested fuel [9]Sample was reanalyzed past EPA recommended holding time [10]The sample was diluted due to the presence of high levels of target analytes resulting in elevated reporting limits [1 I]Laboratory report indicates discrete peak at MTBE and Benzene [12]Laboratory report indicates discrete peak at MTBE [13]The concentration indicated for this analyte is an estimated value above the calibration range of the instrument [14]This sample was analyzed beyond the EPA recommended holding time [ 151 Based on notes in laboratory report and conversation with laboratory(11/19/02) this TPHG result is due entirely to presence of MTBE No other compounds eluted in the TPHG range (Refer to Strattts' Quarterly Groundwater Monitoring Report Third Quarter 2001 dated November 20,2002) [16]The continuing calibration standard was outside of the acceptance criteria [17]The sample was diluted due to the presence of high levels of non-target analytes resulting in elevated reporting limits [1 8]Discrete peak @ C6-C7 [19]Reported result is due to a discrete peak at C5 and has been refected [20]Analyte was also reported in the associated laboratory blank as well as in the sample Result should be considered not detected [21]Initial results maybe biased high as shown by surrogate recoveries above method acceptance limits(due to matrix interference) Sample re-analyzed outside of EPA recommended hold time Initial result reported in the table,and should be considered an estimate [22]Initial result was an estimate beyond the calibration range of the instrument Sample re-analyzed beyond the EPA recommended hold time Initial result reported in the table [23]The reported results may be biased low since the analyses for these analytes were performed beyond the EPA recommended holding time of 14 days [24]The reported results may be biased low as demonstrated by a low surrogate recovery due to matrix interference [25]Initial result not confirmed by re-analysts Re-analysis performed beyond hold time Initial result reported in the table,should be considered an estimate [26]The reported result may be biased low as demonstrated by a low surrogate recovery [27]Discrete peak @ C5 [28]Analyzed EPA Method 826013 [29]The reported result may be biased low due to a low average percent recovery reported in the associated MS/MSD analysis I � Arco_5469_Quarterly Data 5TRA TUS 9of9