Laserfiche WebLink
Sensor Installation <br /> Installation Hardware <br /> The Sump Sensor's Installation kit is shown in Table 1: <br /> Table 1:Sump Sensor Installation Kit(P/N 330020-076) <br /> Item Qty. Description Part No. <br /> 1 2 Mounting strip 330314-001 <br /> 2 2 #4-20 x 3/8"Plastite screw 510500-398 <br /> 3 3 1/4"-20 x 1/2"Bolt,hx hd 503328-001 <br /> 4 3 1/4"-20 Speed nut 511000-232 <br /> 5 2 Wire nut 576008-461 <br /> 6 1 Sealing pack 514100-304 <br /> 7 1 Cord grip 331028-001 <br /> 8 2 Tie wrap 510901-337 <br /> Site Preparation <br /> Check that the Sump Sensor's field wiring is not connected to the console. <br /> Mounting Sensor to Support Member <br /> 1. Make sure no liquid exists in the sump. Failure to comply can result in undetected potential environmental and <br /> health hazards. <br /> 2. Attach one of the mounting strips to the top of the sensor using the 2 Plastite screws provided as shown in <br /> Figure 1. <br /> Important!The sensor must be positioned in the lowest part of the sump and it must be mounted in a true ver- <br /> tical position to ensure proper operation of the float switch contained inside. <br /> 3. Depending on your mounting requirements (again see Figure 1),attach the second mounting strip to the first <br /> strip using two 1/4-20 x 1/2-inch screws and speed nuts.With the sensor resting on the bottom of the sump, <br /> wrap the mounting strip around the support member and secure it using a 1/4-20 x 1/2-inch screw and speed <br /> n ut. <br /> 4. Carefully bend the mounting strip so that the sensor is in a true vertical position and still rests on the bottom of <br /> the sump. <br /> 5. Install the cord grip into the junction box. Feed the sensor cable through the cord grip on the junction box. <br /> Tighten the cord grip nut to ensure a water-tight seal at the cable entry. <br /> 4 <br />