Laserfiche WebLink
• <br /> Tetraethyl lead, an organic form of lead, can cause diseases of the central nervous system, <br /> the kidneys, and the blood Skin absorption of this compound is a major route of entry into <br /> the body, however, it can also be inhaled as a constituent of dust. Care should be taken <br /> to avoid inhalation of and contact with dust on UST sites. The OSHA exposure limit is <br /> 0 075 mg/m3 of air while the ACGIH exposure limit is 0 1 mg/m3. <br /> 2.3 PHYSICAL HAZARDS <br /> Physical hazards vary in type and number among the tasks related to UST operations, and <br /> ~not all of the described physical hazards are necessarily present during individual UST <br /> related projects. However, it is reasonable to expect that some combination of these <br /> hazards will be present, and therefore will be discussed in the plan. Most of these hazards <br /> have specific Standard Safety Procedures that will be attached on a site-by-site basis <br /> SSPs can be obtained through the RSC and/or the HSD. <br /> The weather presents a variety of physical hazards that will vary from season to season, <br /> and must be addressed accordingly High temperatures frequently present the potential for <br /> heat stress When conditions exist for potential heat stress, an appropriate heat stress <br /> monitoring program must be ;included in the plan, and must be implemented and <br /> documented on site Warmer weather also presents the possibility for thunderstorms and <br /> lightning UST projects requiring the use of drill rigs, cranes, backhoes, and similar <br /> equipment will be shutdown in the event of thunderstorms Cold weather presents yet a <br /> different group of hazards including the potential for hypothermia, frost bite, freezing <br /> liquids and surfaces, faulty monitoring equipment, and metal stress. Appropriate <br /> precautions for cold weather operations will be made part of this plan. <br /> Heavy equipment is involved in most aspects of UST closures and site characterizations. <br /> When such equipment is operated by SEACOR or a SEACOR subcontractor, appropriate <br /> inspections and operating guidelines shall be employed as discussed in relevant operating <br /> practices. When work details require the use of hand tools and power hand tools caution <br /> and good judgment must be employed. In addition to general health hazard by way of <br /> electric shock and physical injury, power hand tools can act as ignition sources during UST <br /> operations. Electrical hand tool use requires utilization of Ground Fault Circuit <br /> Interrupters or establishment of an assured ground program Hot work such as the cutting <br /> or welding of tanks is not covered under the plan If these activities are required, an <br /> approved amendment to this plan is necessary. Similarly, the plan does not cover any form <br /> of confined space entry either into a tank or excavated areas. <br /> UST closure and installation will require varying degrees of excavation Physical hazards <br /> encountered during the excavation process range from moving heavy machinery to sloping <br /> and shoring concerns of the excavation itself. SEACOR personnel or their subcontractors <br /> are not permitted to enter any unsecured excavation. Excavations and trenches must <br /> comply with OSHA's standard (29 CFR 1926 651/652). if it is necessary that an excavation <br /> or trench be entered, the provisions of the OSHA standard must be fully implemented A <br /> competent person must inspect all trenches and excavations prior to entry or <br /> commencement of work nearby Prior to excavation a full utility search must be conducted <br /> I <br /> Rev 4/93 2-3 corp-h&slbl,aiikL,sc h&S <br />