Laserfiche WebLink
In-N-Out Burgers NGF 255 Progate Drive Thru Service Manual <br />© 2011, IMI Cornelius Inc.- 15 -Publication Number: 621058475SER <br />2. Remove ice from hopper and clean and sanitize the hopper. (See the Cleaning the interior surfaces section <br />shown later in this manual). <br />3. While cleaning the hopper use the brush provided with the unit to clean the cold plate surface. To accomplish <br />this, the brush needs to be extended through the opening in the bottom of the hopper. <br />Yearly Maintenance: <br />Have the water pump and check valve inspected and cleaned by a qualified service technician. <br />Have the CO2 gas check valve inspected and cleaned by a qualified service technician. <br />Remove the unit’s splash and cold plate cover to clean and sanitize the cold plate surface. (See the cleaning the cold <br />plate section shown later in this manual). <br />Ice Chute Cleaning <br />The Ice chute needs to be cleaned daily to remove buildups. <br />NOTE: The ice chute has an built in safety feature meaning that when the ice chute cover is removed <br />the unit is disabled. If the ice chute cover is not properly installed the agitator and ice chute <br />gate will not function. <br />Cleaning Interior Surfaces (Monthly Cleaning) <br />CAUTION:! <br />When pouring liquid into the hopper, do not exceed the rate of 1/2 gallon per minute. Pouring more liquid into the <br />hopper could result in an overflow situation may result in injury or damage to the equipment. <br />1. Remove agitator assembly. <br />2. Using a nylon bristle brush or sponge, clean the interior of the hopper, top cover and agitator assembly with <br />soap solution. Thoroughly rinse the hopper, cover and agitator surfaces with clean potable water. <br />3. Reassemble agitator assembly. Take special care to ensure that the thumbscrew is tight. <br />4. Using a mechanical spray bottle filled with sanitizing solution, spray the entire interior and agitator assembly. <br />Allow to air dry. <br />5. Remove merchandiser and ice chute cover from unit. <br />6. With a nylon bristle brush or sponge, clean the inside of the ice chute, gasket, and cover with soap solution and <br />rinse thoroughly to remove all traces of detergent. <br />Removing and Reinstalling the Ice Chute <br />1. Grab ice chute and slide up until it comes to a <br />stop. <br />2. Pull forward. <br />3.Properly clean the ice chute. The ice chute is <br />manufactured out of materials that can survive <br />chlorine-based cleaners and warm water <100F. <br />IMPORTANT: Do not put the ice chute into a <br />dishwasher. <br />4. Replace when finished. <br />5. If agitator or ice chute does not operate remove <br />and reinstall chute cover. <br />Figure 9.