Laserfiche WebLink
12 <br />ADJUSTING MIX RATIOS <br />The dispenser comes with the Mix Ratios preset to 35:1. The Left and Right ratios can be set for any ratios <br />between 20:1 and 100:1, (refer the concentrate package or the supplier for the recommended ratio). Once the <br />recommended ratio has been entered, the Ratios can be adjusted to suit local taste preferences (i.e. lighter or <br />darker). <br />Procedure for Adjusting the Mix Ratio to Taste: <br />1) Set the left and right dispense ratios to the recommended ratios for the concentrate to be used - refer to <br />“PROGRAMMING THE DISPENSER” section in this manual. <br />2) Load the concentrate in the cabinet – refer to “LOADING THE CONCENTRATE” section in this manual. <br />3) Allow the dispenser to fill with water and heat up to the Ready temp – refer to “INITIAL FILL AND HEAT” <br />section in this manual. <br />4) Prime both pumps – refer to “PRIMING THE CONCENTRATE LINES” section in this manual. <br />5) Dispense Product (left and right) for approx. 30 sec and discard. This will finish priming the lines and allow <br />the pumps time to adjust to the target RPM. <br />6) Dispense one full cup of coffee (8 oz minimum) from both sides and evaluate. <br /> a) If the coffee is too weak – Decrease the Mix Ratio slightly. <br /> b) If the coffee is too strong – Increase the Mix Ratio slightly. <br />7) Repeat steps 5 and 6 until the desired taste profile is achieved <br />Note: Bunn does not recommend adjusting the Mix Ratio more than 20% from the recommended ratio. Contact <br />your product supplier or service agent, if more than a 20 % adjustment is indicated, as there may be an error <br />with the set up of the dispenser. <br />36026.1 010313 <br />RELEASED FOR PRODUCTION <br />DIR Num: 36026.0001 19, May 2015