Laserfiche WebLink
24 <br />OPERATING THE PRESET PORTION CONTROL DISPENSER <br />(Models LCR-2 PC, LCR-2C PC, LCR-2A PC) <br />Set the Function Selector Switch to Normal and the Mode Selector Switch to Run. <br />Dispensing Preset Portions of Coffee or Hot Water <br />1. Primary Volume Portion Dispense Mode. (Volume 1) Refer to Programming Functions on how to set this <br />amount. <br />a. Place cup on the cup tray beneath the desired dispensing tip. For a large container, flip the cup tray up <br />and place the container on top of the drip tray. <br />b. Momentarily press the appropriate dispense switch. The dispenser will automatically dispense the beverage <br />at the preset amount. Allow the mix chamber to drain at the end of the cycle. <br />c. Remove cup or container. <br />2. Alternate Volume Portion Dispense Mode. (Volume 2) Refer to Programming Functions on how to set this <br />volume. <br />a. Place the appropriate size container beneath the desired dispensing tip. For large containers, flip the cup <br />tray up and place the container on top of the drip tray. <br />b. Momentarily press the Portion Switch. The Portion LED will illuminate for 5 seconds after the Portion <br />Switch is pressed. <br />c. Momentarily press the corresponding Dispense Switch. If the user waits longer than 5 seconds to push <br />the switch, the dispenser will default back to the Primary Volume preset amount. Alternate Portion <br />Dispense Mode can be disabled at any time during the portion dispense by either momentarily pushing <br />the Dispense Switch again or pressing the Stop button. <br />d. Wait for the container to fill and the dispenser to quit dispensing, then remove the container. <br />Push and Hold Dispensing of Coffee or Hot Water <br />Push and Hold Dispense Mode. See Programming Functions on how to set the Preset Volume to Zero. <br />a. Place cup on the cup tray beneath the desired dispensing tip. For a large container, flip the cup tray up <br />and place the container on top of the drip tray. <br />b. Push and hold the corresponding dispense switch until the container is full. <br />c. Remove cup or container. <br />36026.1 010313 <br />Filling Cambros or other large containers: <br />The dispenser is designed primarily for cups or other small containers that will fit under the dispense tips. <br />However, it may be used to fill larger containers (up to 5 Gal) by use of an extension hose on the dispense tip. <br />Removing the Flow Restrictors will increase the dispenser flow rate to 2.5 Oz/sec. (74 mL/sec.) and reduce the <br />time to fill larger containers, (see Setting Dispenser Flow Rate.) <br />Care must be taken to insure that the mixed product flows freely from the dispense tip into the container. <br />1. Use a 5/8” I.D. or larger, NSF (National Sanitation Foundation) approved hose. <br />2. Use as short a hose as possible with no loops, bends or kinks in it. <br />3. Insure that the outlet of the hose is below the dispense tip and that the mixed product flows freely into the <br />container <br />A properly sized and positioned hose will not run full or back up into the dispense tip. Failure to follow these <br />directions can alter the mix ratio and/or cause flooding of the vent tube. <br />NOTE: The temperature of the product being dispensed will start to drop after ~2 gal. continuous draw. Recovery <br />time will be dependent on the temperature of the supply water and the voltage at which the heater coil is being <br />operated. <br />RELEASED FOR PRODUCTION <br />DIR Num: 36026.0001 19, May 2015