Laserfiche WebLink
<br /> <br /> <br /> <br /> <br />Cartridge Tomato Slicer <br />56600-7N 7/32” Slice <br />Operating and Maintenance Instructions <br />Important <br />1. To get the best operation and life from your machine, please read and comply with these instructions. <br />2. Clean machine thoroughly before and after each use following the cleaning instructions below. <br />3. Minimize the use of alkaline cleaners as they may cause pitting and dulling of the finish. <br /> <br />Safety instructions <br />Remember that the blades are VERY SHARP! Be careful when handling and operating the machine to keep hands <br />away from the blades. <br />Preparation <br />1. Set unit on a flat surface. <br />2. If unit fails to work properly when first operated call NEMCO customer service at 1-800-782-6761. <br /> <br />Operation <br />1. Your Cartridge Tomato Slicer comes assembled and ready to use. You may want to install the TABLE STOP for your <br />convenience. <br />2. Pull HANDLE all the way toward you and carefully place the tomato on the SLIDE BOARD between the PUSHER <br />PLATES and the BLADES. CAUTION: SHARP BLADES <br />3. Withdraw your hand. With one quick motion, push the HANDLE toward the BLADES and catch the tomato in your <br />hand or container. <br />4. Remove the sliced tomato from the SLIDE BOARD and repeat the procedure for the next tomato to be sliced. <br /> <br />Cleaning <br />NOTE: Proper maintenance plays an important part in the life span and functioning of the unit. <br />Clean machine thoroughly after each use. <br />1. Be careful of the sharp blades. <br />2. Remove the CARTRIDGE BLADE ASSEMBLY by loosening the CLAMPING KNOBS and lifting the BRIDGE off the <br />BLADE ASSEMBLY. The BLADE ASSEMBY can now be lifted up and off the GUIDE RODS. (NOTE: When replacing the <br />BLADE ASSEMBLY, it will only fit on the machine properly one way. Be sure that the notch in the BLADE <br />ASSEMBLY is aligned with the protrusion in the FRAME.) <br />3. To remove the PUSHER ASSEMBLY for cleaning, remove the THUMB SCREWS and the SLIDE STOP and pull the <br />PUSHER off the end of the SLIDE BOARD. <br />4. Wash with a brush using soap or mild detergent and water. <br />5. Immediately after cleaning, a sanitizer may be used. Be sure to read and follow sanitizer manufacturer instructions. <br />Sanitizer must be food safe and safe for use with Aluminum, Stainless and HDPE plastics. <br />6. To re-assemble, reverse the procedure. <br /> NOTICE: Always rinse the TOMATO SLICER in cold or lukewarm water after it has been washed in hot water! <br />(Hot water will make the SLIDE BOARD expand and may make it hard to push the PUSHER ASSEMBLY until the <br />SLIDE BOARD returns to room temperature.) <br /> <br />IMPORTANT: NEMCO recommends occasional application of mineral oil in the grooves of the slide board. <br /> DO NOT USE ANY TYPE OF COOKING OIL – The GUIDE PLATE will cease up on the SLIDE BOARD. <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br />ITEM #56