WORK PLANS - Laserfiche WebLink

Home Browse Search

EPSON TM-U220 5/03 EPSON TM-U220 - 3 Serial I/F Communications Settings Safety EMI FCC/ICES-003 Class A Safety standards UL 609501950 CSA C22.2 No. 95060950-00 (Tested using the EPSON AC adaptor C.) Environmental Temperature Operating 32 – 122°F Storage 14 – 122°F Humidity 10 – 90% (no condensation) (Storage conditions are without paper and ribbon cassette.) Control Panel LEDs POWER On when power is on. ERROR On when printer is offline. Off when printer is online. Flashes during an error. PAPER OUT On when the printer is out, or nearly out, of paper. Flashes during the printer self-test Buttons FEED This button feeds roll paper or starts a self-test. POWER Turns on printer power. Loading Paper Note:Only use roll paper that meets specifications. Do not use rolls with paper ends glued to the core. Be careful not to touch the manual cutter. It is sharp. 1. Turn on the printer. 2. Using the tab shown below, open the paper roll cover. 3. For Type A only, open the unit using the unit open lever shown at the right below. 4. Remove the used paper core, if there is one. For Type A only, remove the paper take-up spool, and then open the unit and remove any used paper core. 5. Using scissors, cut the leading edge of the paper straight, as shown at the top left in the illustration below. 6. Insert the paper roll as shown on the right below. Note:If you are using 2-ply paper, be sure that the top and bottom layers are aligned at the paper exit. 7. For Type A only, pull out enough paper to reach the bottom front of the printer; then close the unit as shown at the left below. 8. For Type A only, insert the end of the bottom layer of paper (the journal paper) into the paper take-up spool, and insert the spool back into the printer. Be sure the paper is aligned with the spool’s flange. Function Value Baud rate 1200 bps 4800 bps 19200 bps 2400 bps 9600 bps — Parity None Even Odd — Handshaking DSR/DTR XON/XOFF Data length 7 bits 8 bits