Laserfiche WebLink
<br />Electrical Requirements <br /> <br />7403 Electrical Requirements <br />The terminal’s power cord plugs into the bottom of the terminal into a three-wire, <br />Single-phase, 120 or 240 VAC receptacle. The available power cords are described in <br />the System Cables section. <br />The terminal’s internal power supply has a maximum output of 300 Watts and <br />provides power to the terminal, one printer, and peripherals. <br />120 volt 240 volt <br />Voltage Ranges 100 - 127 VAC 200 - 240 VAC <br />Frequency 50/60 Hz 50/60 Hz <br />Current (A) (Max.) 6.3 3.0 <br />Current (A) (Typical) 3.0 1.5 <br /> <br /> <br />Peripheral Power Requirements <br /> <br />The number of peripherals that the terminal can support is dependent upon which <br />peripherals are connected. For planning purposes, use the RealPOS 70XRT Power Matrix <br />(B005-0000-1876) to calculate the power requirements for your specific system <br />configuration. <br />Note: This file requires Microsoft Excel to run. <br /> <br /> <br />Store AC Wiring Requirements <br />The customer must provide suitable AC power for the terminals, associated <br />equipment, and devices. A dedicated unswitched power line dedicated to the NCR <br />equipment installation is recommended. Refer to the NCR Workstation and Peripherals <br />AC Wiring Guide (BSTO-2115-53) for store AC wiring requirements. The AC outlet <br />must be installed near the terminal and easily accessible to the operator. <br />NCR RealPOS 70XRT Site Preparation 31 <br />Environmental Requirements <br /> <br />