WORK PLANS - Laserfiche WebLink

Home Browse Search

Wall Mounting 1. Remove the mounting plate locking screws from the back bottom corners of the unit and detach the mounting plate from the back of the unit. Figure 1. 2. Keeping the mounting plate level, center it over the doorway opening. Be sure the lipped edge of the plate is at the top. Figure 2. Note: The bottom edge of the mounting plate should be no more than 108'' from the floor. Never install your Air-Pro Air Door in an adverse environment, such as, near splashing water, excess steam, explosive or corrosive gases. 3. Mark the pre-drilled holes, remove the plate and check to make sure you are tying into firm supporting material, i.e. studs, header or block. Note: There should be at least 4 secure mounting holes used. If not, drill 4 new holes in the mounting plate to accommodate a secure attachment. Drill the wall holes. 4. Attach the mounting plate. (Screws not supplied) Solid Wall Mounting 1. Preform the first two steps under “Wall Mounting” (see above). 2. Mark the 4 outside pre-drilled holes and remove the plate. 3. Drill the 4 anchor holes and place anchors in each hole. Figure 3. 4. Attach the mounting plate. (Screws not supplied)Figure 2 Figure 3 1 BEFORE PROCEEDING, PLEASE READ AND SAVE THESE INSTRUCTIONS If the Air Door unit has been damaged in shipping, immediately notify the transport company. MOUNTING (Interior Applications)Air Door Assembly Locking Screws Mounting Plate Mounting Brackets Threaded Rods Bracket Collars Lipped Edge Smooth Edge Pre-Drilled Mounting Holes No more than 86'' from the floor Mounting Plate Figure 1 Mounting Plate FLOOR DOORWAY OPENING INSTALLATION INSTRUCTIONS 2 3 1 2 34 Figure 4 Ceiling Mounting If mounting the air door to the ceiling is necessary, you will need to order our mounting brackets (optional). Also, 4 threaded rods (supplied by others) will be needed. 1. Secure the 4 threaded rods to the ceiling at the proper distance from the floor taking the height of the air door unit into consideration. 2. Using a hex bolt, washer and nut, attach each bracket to the mounting plate using the pre-drill holes. Make sure the lipped edge of the plate is at the top. 3. Holding the assembly in place, fasten the rods to the bracket collars. Figure 4. Hex Bolt Nut Washer Lipped Edge Smooth Edge • Not to exceed 3'' By dropping the Air Door on its side during shipping the blower wheels may come out of the side bushing. This must be corrected prior to operating the unit. 1)Remove the intake grill and the four screws on the side of the unit to remove the end plate. 2)Loosen the screw that attaches the blower wheels to the motor shaft and remove the blower wheels. 3)Insert the metal wheel from the end of the blower wheels into the rubber bushing. 4)Slide the blower wheels into the side of the unit over the motor shaft and reattach the four screws to the side of the unit. 5)Tighten the blower wheels to the motor shaft and replace the intake grill. IMPORTANT