COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

Product code ECH7080 Date of issue _.larch 2014 Version 11.01 Product name MEDIUM CLEARCOAT HARDENER 8 . Exposure controls/personal protection OSHA = Occupational Safety and Health Administration. TLV = Threshold Limit Value R = Respirable TWA = Time Weighted Average Z = OSHA 29CFR 1910.1200 Subpart Z-ToAc and Hazardous Substances Consult local authorities for acceptable exposure limits. Recommended monitoring If this product contains ingredients with exposure limits, personal, workplace procedures atmosphere or biological monitoring may be required to determine the effectiveness of the ventilation or other control measures and/or the necessity to use respiratory protective equipment. Reference should be made to appropriate monitoring standards. Reference to national guidance documents for methods for the determination of hazardous substances will also be required. Engineering measures Use only with adequate ventilation. Use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure to airborne contaminants below any recommended or statutory limits. The engineering controls also need to keep gas, vapor or dust concentrations below any lower explosive limits. Use explosion-proof ventilation equipment. Hygiene measures Wash hands,forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Contaminated work clothing should not be allowed out of the workplace. Wash contaminated clothing before reusing. Ensure that eyewash stations and safety showers are close to the workstation location. Personal protection Eyes Safety glasses with side shields. Hands Chemical-resistant, impervious gloves complying with an approved standard should be worn at all times when handling chemical products if a risk assessment indicates this is necessary. Considering the parameters specified by the glove manufacturer, check during use that the gloves are still retaining their protective properties. It should be noted that the time to breakthrough for any glove material may be different for different glove manufacturers. In the case of mixtures, consisting of several substances, the protection time of the gloves cannot be accurately estimated. Gloves butyl rubber Respiratory By spraying: air-fed respirator. By other operations than spraying, in well ventilated areas, air-fed respirators could be replaced by a combination charcoal filter and particulate filter mask. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Skin Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Environmental exposure Emissions from ventilation or work process equipment should be checked to ensure controls they comply with the requirements of environmental protection legislation. In some cases,fume scrubbers,filters or engineering modifications to the process equipment will be necessary to reduce emissions to acceptable levels. Restrictions on use Persons with a history of asthma, allergies or chronic or recurrent respiratory disease should not be employed in any process in which this product is used. 9 . Physical and chemical properties Physical state : Liquid r. G1q§qd cam; 0"C(104°F) Explosionlimiits Lower 1.1% Color Not available. Odor Not available. pH Not available. Boiling/condensation point >37.78°C (>100°F) Melting/freezing point Not available. Specific gravity 1.07 United States -Canada -Mexico Page: 5/10 P-d by IHS