INSTALL_2020 - Laserfiche WebLink

Home Browse Search

5. Place the remaining ring over the sump entry fitting in the 10. Do not disturb assembly until the adhesive is cured.This inside of the sump and rotate to the desired angle. Make includes bonding of pipe to the sump entry fitting and alignment mark on both the sump wall and the ring when installing the threaded outlet fitting. See adhesive kit at the desired angle to make the"free"surface of the ring instructions for cure times. as close to perpendicular(square)to the axis of the fitting as possible. 11. The use of an industrial hot air gun may speed up the curing process. Do not overheat. 6. Mix one 8 oz. PSX-34 or one 8069 adhesive for each fitting per the instructions in the adhesive kit.Filler should 12. Remove 1/4 inch plastic threaded outlet protector. be used with 8069 to insure proper sealing of alignment Apply adhesive only to the 1/4 inch fitting and screw rings. into the 1/4 inch threaded outlet.Tighten to 40 in.-Ibs.or 11/2-2 turns past hand tight. 7. Apply adhesive generously,approximately 1/16 inch thick, to the inside and the outside of the sump walls where the NOTE: Over-tightening the tapered threads of the fitting alignment rings are located. Coat the edges of the hole may damage the fitting body. DO NOT OVER-TIGHTEN. cut in the sump wall.Apply a thin coating of adhesive to the bonding surfaces of the alignment rings. After installing the fitting, be sure the interstitial space is free from excess adhesive. Install a short hose and blow 8 Line up rings with alignment marks and press together excess adhesive through the air passage. firmly holding the fitting in place from the outside of the sump. NOTE: Verify with testing company or monitoring manufacturer if a larger thread is needed for their 9. Slide the metal retaining ring over the inside section of equipment. After the port fitting is installed, do not the sump entry fitting and against the inner alignment remove. ring until all the rings are tight against both sides of the sump wall. (A short section of 4 inch pipe may be used 13. Connect only flexible tubing or hoses to the port fitting. to drive the metal retaining ring over the fitting). Be sure there is an adhesive bead visible between the rings and NOTE:Tubing or hoses must be rated to full vacuum. the sump wall.The metal ring must hold the assembly in position while the adhesive cures. If the assembly is not Drawings below show the assembly of the fitting and tight against the sump wall,firmly press the sump entry associated pipe when using either size-over-size fitting against the outside sump wall while pressing the containment systems or coaxial pipe. metal ring against the alignment ring on the inside.Clean excess adhesive from all bonding surfaces. ADHESIVE BEAD T _ T T RETAINING RETAINING RING RING 2