COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

STEP 13 : DIMPLE FIRST HOLE STEP 15 : DIMPLE REMAINING HOLES Remove tool . Remove any chips or burrs from the drill- Remove any chips or burrs from the drilling operation . ing operation . Place the assembly on a solid surface . Dimple the next (2) holes as done in Step 13 . Make sure Using the punch supplied with the 71 SO-TOOL, 71 SO- the assembly is on a solid surface when punching . After TOOLC, and 71 SO-TOOLCT, align the tip of the punch punching , remove any chips that may have fallen into with the drilled hole and dimple the upper drop tube by the inlet tube screw hole . striking the punch with a hammer until the drop tube is formed into countersunk hole in the inlet tube . After punching , remove any chips that may have fallen into the inlet tube screw hole . Align punch with ( > drilled hole Figure 15 STEP 16 : ASSEMBLE OTHER SCREWS Apply black moly grease to screws and tighten the oth - er (2) screws into inlet tube with a screwdriver as done Figure 13 in Step 14 . Use only the taptite screws that are supplied with the unit . Seating torque is 20 in - lbs min . to 35 in - STEP 14: ASSEMBLE FIRST SCREW lbs max. Do not over tighten . Ensure that the drop tube was formed into the counter- sunk screw hole as shown in Figure 14 if not return to STEP 17 : APPLY GREASE TO LOWER O- RING AND Step 13 . Apply black moly grease to screw and tighten BODY THREADS first screw into inlet tube with a screwdriver . Use only Apply black moly grease to the lower tube o- ring and the taptite screws that are supplied with the unit . Seat- body threads as shown . Make sure coverage is com - ing torque is 20 indbs min . to 35 in - lbs max. Screw head pletely around the o- ring . Install o-ring in groove just should be flush with the drop tube . Do not over tight- above threads . en . Apply grease around o- ring Ensure the drop tube Is formed Into countersunk hole O -ring Figure 14 groove Body threads Figure 17 11