COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM VIII . MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational? 2 ❑ ❑ Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, El ❑ ❑ functionally tested , and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their 2 ❑ ❑ proper operation? Was monitoring system set-up reviewed to ensure proper settings? E ❑ ❑ Was the monitoring panel's backup battery visually inspected , functionally tested , and confirmed operational? R ❑ ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically EI ❑ ❑ disconnected ? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? (] ❑ ❑ Which sensors initiate positive shut down? (Check all that apply.) (] Sump ❑ Under-dispenser containment If alarms are relayed to a remote monitoring station , is all communications equipment (e .g , modem) operational? (] ❑ ❑ For any answer of "N" above, describe in section IX how and when these deficiencies were or will be corrected. IX. COMMENTS X. IN -TANK GAUGING TESTING 1 Check this box if tank gauging is used only for inventory control . (Do not complete this section.) ❑ Check this box if NO tank gauging equipment is installed . (Do not complete this section.) Y N NA This section must be completed if in-tank gauging is used to perform leak detection monitoring. Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing for ground ❑ ❑ faults? [ Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally tested , 0 ❑ ❑ and confirmed operational? Was accuracy of system's product level readings tested ? I] ❑ ❑ Was accuracy of system's water level readings tested? I] ❑ ❑ Were all probes reinstalled properly? El ❑ Were all items on the equipment manufacturer's maintenance checklist completed ? ❑ ❑ For any answer of "N" above, describe in section XI how and when these deficiencies were or will be corrected. XI . COMMENTS Probes were tested _ = Y Yes, N No, NA Not Applicable i