COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

MONITORING SYSTEM CERTIFICATION CERTIFICATION / TEST DATE11 , September 17, 2018 %1 . FACILITY A2 . OWNER Name Teichert Mobile Equipment Name Teichert Construction Address 120 Frank Circle , Stockton, CA 95206 Address P. O. Box 15002, Sacramento, =96861 Phone # 916-366-6631 Phone # 9164864767 Contact Steve Schamaun Contact Steve Schamaun D . RESULTS OF TESTING / SERVICING Make / Model of Monitoring System : VeedermRoot TLS -350 SN Software Version Installed . 328 , 03 Complete the following checklist: I Yes ❑ No * 1 Is the audible alarm operational? Yes ❑ No * is the visual alarm operational? Yes ElNo * Were all sensors visually inspected, functionally tested, and confirmed operational ? Yes ❑ No * I Were all sensors installed at lowest point of secondary containment and positioned so that other equipment I will not interfere with their proper operation? Yes ❑ No * If alarms are relayed to a remote monitoring station , is all communications equipment (e. g. modems ) ❑ N/A operational? Yes I ❑ No * For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment EJ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes : which sensors initiate positive shutdown ? (check all that apply) N Sump/Trench sensors ; 0 Dispenser Containment Sensors. Yes ❑ No * I Did you confirm positive shut-down due to leaks and sensor failure/disconnection ? Yes W ❑ Nc * For tank systems that utilize the monitoring system as the primary tank overfill warning device ( i . e. no El N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent of tank capacity_does the alarm trigger? 50% ❑ Yes * No [ Was any monitoring equipment replaced? If yes, identify specific sensors, probes , or other equipment replaced * i and list the manufacturer name and model for all replacement parts in Section E, below. _ Yes ❑ No Was any liquid found inside any secondary containment systems designed as dry systems? Yes (Check all that apply) ❑ Product Water. If yes, describe causes in Section E below. Yes__ ❑_ No " I Was monitoring system set-up reviewed to Insure proper settings? Attach set-up reports, if applicable. ❑ No * Is all monitoring equipment operational per manufacturer's specifications ? " In Section E below, describe how and when these deficiencies were or will be corrected . E . COMMENTS Removed a small amount of water from the Waste Oil fill sump. © 2016 Walton Engineering, Inc. Page 2 of 3