Laserfiche WebLink
tl ® tl 0 n ; - -^� <br /> KYDEX° Thermoplastic Sheet <br /> MSDS - 101 <br /> Section T Handling Precautions: Dust levels should be kept below respiratory dust concentrations of 5 mg/m3. Take proper care <br /> Handling and when moving, loading, or unloading. Electrostatic charge may build up during handling; grounding of equipment is <br /> Storage recommended. <br /> Storage Requirements: Store in a dry area below 100°F (37.7°C) . <br /> Regulatory Requirements: KYDEXO sheets are not regulated . <br /> Section 8 : Engineering Controls : Maintain levels of airborne contaminants below exposure levels by controlling general and local <br /> Accidental Release room ventilation in areas where machining, cutting or thermoforming occurs. Ground equipment to prevent build up <br /> Measures of electrostatic charge. <br /> Ventilation : Provide general or local exhaust ventilation systems to maintain airborne concentrations below OSHA PELs <br /> (Sec.2). Local exhaust ventilation is preferred because it prevents contaminant dispersion into the work area by <br /> controlling it at its source. <br /> Respiratory Protection : Seek professional advice prior to respirator selection and use. Follow OSHA respirator regulations <br /> (29 CFR 1910. 134) and, if necessary, wear a MSHA/NIOSH-approved respirator. Select respirator based on its suitability <br /> to provide adequate worker protection for given working conditions, level of airborne contamination, and presence of <br /> sufficient oxygen. Warning! Air-purifying respirators do not protect workers in oxygen-deficient atmospheres. If respirators <br /> are used, OSHA requires a written respiratory protection program that includes at least: medical certification, training, fit <br /> testing, periodic environmental monitoring, maintenance, inspection, cleaning, and convenient, sanitary storage areas. <br /> Protective Clothing/Equipment: Wear protective eyeglasses or chemical safety goggles, per OSHA eye- and face-protection <br /> regulations (29 CFR 1910. 133) . Contact lenses are not eye protective devices. Appropriate eye protection must be <br /> worn instead of, or in conjunction with contact lenses. <br /> Safety Stations : Make emergency eyewash stations,quick-drench showers, and washing facilities available in work area. <br /> Contaminated Equipment: Not applicable <br /> Section 9 : Physical State: Solid Water Solubility: Negligible <br /> Physical and Appearance and Odor: Opaque plastic sheets; Other Solubilities : Tetrahydrafuran <br /> Chemical none or slight odor Boiling Point: Not available <br /> Properties Odor Threshold : Not available Freezing Point: Not available <br /> p Vapor Pressure: Not available Viscosity: Not available (solid) <br /> Vapor Density (Air= ] ) : Not available Refractive Index: Not available (opaque) <br /> Formula Weight: Not available (Mix) Surface Tension : Not available <br /> Density: 1 .3- 1 .5 g/cc % Volatile: Not available <br /> Specific Gravity (H20 = I , at 4 °C) : 1 .3- 1 .5 Evaporation Rate: Not available <br /> pH : Not available <br /> SEKISUI SPI <br /> ISO 9001 and 14001 Certified <br /> Customer Service <br /> 6685 Low St, Bloomsburg, PA 17815 USA <br /> Phone: 800325.3133, + 1 .570.389.5810 <br /> Outside the US: + 1 .570.389.5814 <br /> Fax: 800.452.0155, + 1 .570387.7786 <br /> Email: info@sekisui-spi.com <br /> Technical Service <br /> Phone: 800.682.8758 <br /> Fax: + 1 .570387.8722 <br /> Outside the US: + 1 .570387.6997 <br /> techseMce@sekisui-spi.com <br /> Saldsui -Spi .com <br /> O 2014 SEKISUI POLYMER INNOVATIONS, I.I.C. All rights reserved. KYDEX is a registered trademark of SEKISUI POLYMER INNOVATIONS, LLC. i 091614 <br /> i <br />