Laserfiche WebLink
From 11/03/2008 1513 #164 P 011/033 <br /> I. MONITORING: All monitoring equipment must be listed in the State Waster Resources Control Board <br /> Division of Clean Water Program Local Guidance Letter 113. <br /> Check <br /> BoxCode <br /> Section <br /> All secondary containment units (e.g. tank annular spaces, secondary piping, sumps, under- <br /> 21 azcR dispenser containment,etc.)monitored for leaks using approved electronic leak detection systems. <br /> 2636 <br /> All sensors must be located at the lowest possible point so that they may detect a leak at the <br /> earliest opportunity. <br /> Electronic monitoring sensors located at the following points: <br /> ° At the bottom of the interstitial space of each secondarily-contained tank,positioned as <br /> near as possible to the bottom of the tank. <br /> Manufacturer Model 37ja©gn___ <br /> ° In each collection sump,positioned as near as possible to the bottom of the collection <br /> sump. Additionally, in any sump acting as secondary containment for unused tank <br /> openings which connect to the primary space. <br /> 23 CCR <br /> 2632 Manufacturer - Qoo`} Model J C4 1 323a- <br /> 26.40(d) <br /> ° In dispenser pans which do not drain into secondary containment piping. (Note. A <br /> mechanical switch which triggers a shear valve may be substituted but this system will <br /> not qualhr for the annual line tightness test exemption under 23 CCR 2636(g)), <br /> Manufacturer 6s,,,Ja.r- P&& Model ?'Tq 3,9n <br /> ° Along secondarily-contained pipe runs which do not meet the 1/4 inch-per-foot slope <br /> requirement,positioned in the depressed or low-lying areas. <br /> Manufacturer Model N /A <br /> 23 CCR Automatic line leak detectors installed to monitor underground pressurized piping. <br /> 2636th <br /> Q1 NSC Manufacturer V Model gj 80__0 p( <br /> 25290.1(h) <br /> 25240.2 <br /> Alarm panel provides both audible and visual alarms. It is located in a protected area and within <br /> 23 CCR sight and hearing distance of on-site personnel and hard-wired to a dedicated circuit. <br /> 2632(cM2)(11) Manufacturer r Pw Model TS 3S-0 <br /> J. OTHER COMPONET INFORMATION: <br /> COMPONENT MANUFACTURER MODEL COMPOSITION <br /> P'-ITkP tf f�t�85 C <br /> SUMP Vj__s .b 145s h�/7AP z�� car �� Cass <br /> UNDER-DISPENSER lwtlSe {/ 1:1,16U.4*0 <br /> CONTAINMENT =`i �gss <br /> PENETRATIONS V-'2-t 'o ric-5 <br /> Revised 07/31/08 8 <br />