Laserfiche WebLink
Underground Storage Tank <br /> Overfill Prevention Equipment Inspection Report <br /> 6. OVERFILL PREVENTION EQUIPMENT DETAILS <br /> Tank ID (one OPE per column) Tank- 1 Unleaded Tank-2 Unleaded Tank-3 Unleaded Tank-4 Unleaded <br /> Are both vent and tank riser piping ❑ Yes ❑ Yes ❑ Yes ❑ Yes <br /> secondarily contained? Eia No 5a No 5a No [id No <br /> OPE Model OPW 71 SO-4" OPW 71 SO-4" OPW 71 SO-4" OPW 71 SO-4" <br /> What is the OPE response when activated? Eia Shut off 5a Shut off 5a Shut off [ia Shut off <br /> (Check all that apply.) Flow Flow Flow Flow <br /> ❑Restricts ❑Restricts ❑Restricts ❑Restricts <br /> Flow Flow Flow Flow <br /> ❑ Audible ❑ Audible ❑ Audible ❑ Audible <br /> Alarm Alarm Alarm Alarm <br /> ❑ Visual ❑ Visual ❑ Visual ❑ Visual <br /> Alarm Alarm Alarm Alarm <br /> Are flow restrictors installed on vent piping ❑ Yes* ❑ Yes* ❑ Yes* ❑ Yes* <br /> that may interfere with the OPE operation? 52 No 52 No 52 No 52 No <br /> At what level in the tank is the OPE set to 105 3/8" 105 3/8" 105 3/8" <br /> activate? Inches from bottom of tank <br /> What is the percent capacity of the tank at 95% 95% 95% <br /> which the OPE activates? <br /> Is the OPE in proper operating condition to Eia Yes 5a Yes 5a Yes ❑ Yes <br /> respond when the stored substance ❑ No ❑ No ❑ No ❑ No <br /> reaches the designated regulatory level? <br /> 7. SUMMARY OF TESTING RESULTS <br /> OPE Inspection Results 5a Pass 5a Pass 5a Pass ❑ Pass <br /> ❑ Fail ❑ Fail ❑ Fail 5a Fail <br /> 8. COMMENTS <br /> Describe all results marked "Fail"and each proposed remedy. <br /> ***Tank-4 failed drop tube test and will need to be replace** <br /> ***Tank-5 failed due to wrong drop tube installed, Site has Phil-Tite buckets but OPW 71 SO-4 installed*** <br /> ***Drop Tube needed on site are Franklin Fueling Defender Series Part#708592902*** <br /> * Mark here if: <br /> ❑ Flow restrictors interfere with overfill prevention and equipment repairs required. <br /> Additional copies of this page may be attached. <br /> Attach tank chart(s), measurements, calculations, and In-Tank Setup report(s) <br /> Page 2 of 2 <br />