COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

OSCOPE OF WORK: 1 . EXISTING FILL SUMP SENSOR WIRES, STP SUMP SENSOR WIRES AND STP TURBINE WIRE TO BE REUSED , 2 , INSTALL THREE (3 ) NEW SINGLE-WALL STP SUMPS . EXISTING FIBERGLASS WRAPS (ON COLLARS) TO REMAIN IF NO AIR-VOIDS OR DELAMINATING EXIST, 3 , INSTALL TEN ( 10) NEW DISPENSERS , NEW SINGLE-WALL DISPENSER SUMPS , SHEAR VALVES , FLEX CONNECTORS , BRACKETS AND HARDWARE . SENSOR WIRE TO BE REUSED . 4 , INSTALL NEW 2" SINGLE-WALL FRP VENT PIPING FROM TANKS TO VENTS , INSTALL NEW SINGLE WALL VENT TRANSITION SUMP AND NEW VENT RISERS , 5 , SOIL SAMPLING AS REQUIRED BY CUPA AND OTHER AHJ 'S . CONTRACTOR TO VERIFY, 6 , INSTALL NEW 3" OVER 2" DOUBLE-WALL FRP PRODUCT PIPING FROM TANKS TO DISPENSER SUMPS , 7 , INSTALL NEW 2" AND 3" VAPOR PIPING FROM TANKS TO DISPENSER SUMPS . 8 , INSTALL SIX (6) NEW DOUBLE-WALL SPILL BUCKETS AND NEW FILL AND VAPOR RISERS . 9 , INSTALL THREE (3) NEW EMCO WHEATON COMPOSITE STP MANWAYS , 10 , INSTALL FOUR (4) NEW FE PETRO VARIABLE-SPEED STP'S , 11 , INSTALL NEW STAINLESS STEEL PRODUCT PIPING , FLEX CONNECTORS , BALL VALVES , ADAPTERS AND FITTINGS IN THREE (3) TANK SUMPS , 12 , INSTALL THREE (3) NEW TLM PROBE RISERS , ADAPTERS AND CAPS , 13 , BACKFILL , INSTALL REBAR AND RESURFACE DRIVE SLAB AND TANK SLAB CONCRETE TO MATCH EXISTING , MANWAYS TO BE SET WITH 2" CONCRETE CROWN AT 24" OFF EDGE . 14, INSTALL ASPHALT SURFACES TO MATCH EXISTING , WHERE AFFECTED . 15, INSTALL SELF-LEVELING JOINT EPDXY AT ALL CONSTRUCTION JOINTS . 16, PERFORM FULL MONITORING SYSTEM CERTIFICATION AND START-UP VAPOR RECOVERY TESTING . 17 , COORDINATE ALL REQUIRED INSPECTIONS WITH JURISDICTION AUTHORITIES AND THIRD-PARTY INSPECTORS , 18 , BACKFILL EXCAVATION WITH PREVIOUSLY EXCAVATED MATERIALS . 19 , CLEAN UP THE SITE AND REMOVE ALL CONSTRUCTION DEBRIS , INCLUDING LOT SWEEPING OF AFFECTED AREAS .