COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

9. AST will withstand frost-heave XXYes No AST is located in secured lubricants berm not subiect to weather conditions ` 10. AST previously relocated? Yes XX No 11. AST Corrosion Protection_Tank is covered in paint,with no evidence of external corrosion. Tank has. no specific corrosion protection beyond the paint. No part of the AST touches the ground. The base of the AST is steel raised 1 %Z inches from the concrete pad. There is no evidence of internal corrosion takin lace. Tank's construction material is carbon steel. As this tank is not in any contact with the ground,there is no need for further corrosion protection such as cathodic corrosion protection. 12. AST Spill Prevention Equipment(describe,) None-recommend/not req'd---Kreuger gauge Filling is a remote operation & product is not handled outside of the intended containers. Tank has integral secondary containment. Pump has a check valve to prevent siphoning from tank back thru pick up hoses. Tank has continuous electronic monitoring with a BJ Enterprises Sentry siren alarm,which actuates at 90% capacity. Fillin operations consist of utilizing a portable coolant exchange Uump which delivers product to the temporary 55 gal. poly drum and is pumped to the waste coolant tank via the ARO pump on the top of the tank. The system has a pneumatic auto shut down device which is an FMM Services hiiih level shut down. System has manual ball valve shut down at the pump. Spill Prevention Sensor was removed and inspected and operated. The sensor float was measured and it was determined that the tank strobe alarm actuates at 90%of tank capacity and the auto shut down device actuates at 95%of capacity at which time it shuts down pumpin,,operations of the pump itself. 13. Overfill Protection: (describe) Manual Fill does not require shut-off valve. 14. Toxic ConsiderationsIthylene and propylene glycol are toxic by ingestion. Many of the corrosion and antifoaminginhibitors added to antifreeze are also toxic. Propvlene glycol is also toxic and combustible and can react with other chemicals. It requiresproper storage and handling. Both ethylene and Propylene alycoI are water soluble. Improper disposal results in thecontamination of drinkine water, roundwater and land surfaces. Antifreeze is toxic to humans and animals.Waste antifreeze contains heavy metals such as lead, cadmium and chromium in hi2h enough levels to]2otentiaHl make it a re ulated hazardous waste so mast states strictly regulate antifreeze disposal.Antifreeze generators and state and local programs should not [lump spent antifreeze on land or discharge it into a sanitar,Lsewer,_storm drain,ditch dry well,or septic system; dumping antifreeze can cause serious water quality problems and might harm people, pets,or wildlife.The short term storage of waste antifreeze is only accentab_1_e assn interim measure to permit time for the collection of sufficient volumes for cost effective transport to a recycling or disposal facility. 15. AST secondary containment(material/design/listed) AST has integral secondary containment via double_ wall construction to completely capture any leaks from primary vessel. Integral secondary containment was tested, is intact and AST is suitable for continued usage. AST sits within a locked lubricants room within a concrete berm structure. Leak detection is visually ascertained via visual inspection of secondary containment area which was fully inspected and found to be free from any li uids. If Berm is utilized as secondary containment,dimensions follow: W 222 `;x L 471 "x Ht 48 "xthickness 6 "-displacement: 21,727 gallons 16. Damage to AST or systems.No damage reported by Owner/Operator. Upon inspection,no evidence of weld breaks unctures cracks or other structural darns a to the tank. Leak detection is assured via inspections of the secondary containment. Steel thickness measured to .110 in. average. 17.Comments/Test Results: a)camera confirms no sidewall dischareefleak, b) hydrocarbon sensor confirms no sidewall discharge/leak a. Dimensions of AST:Primary Vessel=275 gallons capacity total Dimensions: Primary Tank: 44 in. diameter/elliptical x 61 in. L x in. Ht/clearanc_e_-_5" Seconds Tank: n/a in.W x n/a in. L x n/a in. Ht