Laserfiche WebLink
TESTABLE PROCEDURE ONl!Yr FOR STANDARD IVIOD- STEP 3T: DETERMINE CABLE LENGTH <br /> ELS, PROCEED TO NEXT PAGE. Run cable along upper tube and over the top plate on <br /> the float bracket as shown . With the float in the down <br /> STEP 1T: INSTALL SOCKET ADAPTOR ASSY position (as shown in Figure 31) align loop in cable with <br /> Put cable thru threads in Inlet tube and out thru cable rivet and top hole in float bracket. Use the rivet as a <br /> port on side of inlet tube. Thread the socket adaptor template to size the loop In the cable and pull cable <br /> assembiynnger tight into the inlet tube . Notes the ca- tight and crimp ferrule with crimping tool / pliers onto <br /> ble port on the inlet tube must be in line with the float cable at this location. Trim excess cable with wire cut- <br /> as shown previously in Figure 8A. ter / scissors . For reference, from the seam where the <br /> upper tube and valve body meet to the end of the cable <br /> Socketafter trimming will require approximately 3 .5" of cable. <br /> adaptor <br /> assembly Cable over float bracket <br /> Cable � ..:�;._ ,-`-:�.�_� �'- `1:•-.,. <br /> Seam <br /> port ,. <br /> Figure 3T <br /> i <br /> STEP 4T: ATTACH CABLE TO FLOAT BRACKET <br /> i=lgure 1T Ensure cable is over the float bracket. Using the sup- <br /> plied rivet align loop in cable with top hole In float <br /> STEP 2T's PASS CABLE THRU FERRULE bracket and pass rivet thru cable loop and float bracket <br /> Pass cable thru ferrule. Loop cable and then pass cable hole. Using rivet tool for 1 /8" dia mandrel attach rivet <br /> back thru ferrule. Keep ferrule loose until cable length and cable to the float bracket. See. last page for list of <br /> is determined in the next step. Note. If cable end frays replacement cable parts, <br /> It may be necessary to trim the cable again to pass thru <br /> ferrule. -'`~ Attach rivet to top hole <br /> 1 /8" mandrel x4- / <br /> Fse <br /> rivet . . .:.:..-�._.,.�:: <br /> KZ <br /> Ferrule <br /> Figure 4T <br /> Trim <br /> cable STEP ST: ENSURE PROPER CABLE OPERATION <br /> ,..-�' <br /> after Unthread the socket adaptor assembly from the inlet <br /> tube and ensure float and poppet move freely when <br /> step 3T Loop socket adaptor assembly is pulled on. It should only <br /> require 3" to 4" of movement in order to actuate the <br /> Figure2T float and poppet. Thread socket adaptorassemblyfin- <br /> ger tight into inlet tube after testing. <br /> 13 <br /> i <br />