COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

EBW Phase I Equipment Required Inspection & Maintenance Spill Containment Manholes • Perform inspection and maintenance duties at least once a year. • Remove any standing liquid and dispose of it properly. • Brush all buildup off of the brass drain valve screen of applicable). • Remove all dirt and foreign materials. • Scrape all foreign materials away from the tank lid sealing surfaces. • Should it be necessary to replace a drain valve due to breakage or considerable contamination buildup, use EBW 705-337-19 Replacement Drain Valves only. • Perform a leak test using the established "Pressure Integrity Test" for a combination of Drop Tube, Drain Valve, and Overfill Prevention Device (TP201.1 D). • Use 90079 Drop Tube Isolation Test Kit. Rotatable Fill & Vapor Adapters, Dust Caps & Probe Riser Adapters • Perform inspection and maintenance duties at least once a year. • Inspect all product and vapor riser dust cap seals for damage. If damage is observed, replace the seal with either the Aluminum Vapor Cap Seal or the Nylon Product Cap Seal. • Perform Rotatable Adapter maintenance as specified by Phil -rite Enterprises, Inc. Perform established 'Static Torque Test", TP201.1 B. • Leak testing should be accomplished during the "Pressure Integrity Test" for a drain valve or Drop Tube Mounted Overfill Valve, TP201.1 C or TP201.1 ❑. Annual maintenance of the probe riser cap assemblies is normally not required. Whenever probe service is necessary, inspect the service cap seal for damage and replace it, if necessary, at that time with a Probe Riser Cap Seal. C 2015 F-6308 rev 3 Drop Tube Mounted Overfill Prevention Valves • Perform inspection and maintenance duties at least once a year. • Inspect the inside of drop tubes for broken dip sticks or noticeable damage to the valve flapper. If any damage is observed, then the valve must be replaced. • If it has not already performed during drain valve testing, leak test the Drop Tube assembly using the established "Pressure integrity Test" for Drop Tube/ Overfill Prevention Device (TP201.1 C or TP201.1 ❑). EBW doesn't require that the drop tube be pulled for inspection unless damage is noted. Should local authority require removal of the drop tube, the following seals and inspection steps are necessary: • Replace Drop Tube Isolation Gland (if applicable) seal kit -90090 • Replace Drop Tube Flange Gasket --11182-01 • Inspect the Tank Bottom Protector for freedom of movement. Repair or replace if necessary. • Inspect OPD components, use instructions on EBW from 6329. • inspect drop tube joint sealant. Repair with EBW part # 11372-01 only. Ball Floats & Extractor Valve Bodies • No annual maintenance is required. Pressure Vacuum Vent Valves • Perform the required maintenance as specified by Husky Corporation. At least once every three years, unless otherwise specified by a local authority, perform the established "Static Pressure Performance Test" jP201.3j. Please contact Technical Support if assistance is needed. 460 Franklin Fueling Systems 3760 Marsh Road Madison, WI 53718, U.S.A. Tel: +1 608 838 8786 Tel: USA & Canada 1 Boo 225 9787 Tei; Mexico 001 800 738 7610 www.f ran kl i of Ue I i ng. c o m